Thats it now 🙂 thanks tim 🙂
Finally got my led board set up and working, I cant seem to get the #clkxxx function to work, the diag led flashes but there is no output but I can use the countdown, any ideas what I need to do?
It's been a while.. but wasn't the countdown designed to go on two panels? In which case, perhaps you're jumper setting on the Trik-C is set for "the other panel". Can you double check the Trik-C is set for panel "1"?
(Again.. I may be completely off base here.. this all from a fuzzy memory)
The countdown function is fine, its the clock function that I cant get to work
Yes.. but if the countdown is writing to two screens (one and two)...
... and you are seeing one of them (for arguments sake.. lets say.. screen TWO)...
But the clock is only writing to ONE screen... (lets say... screen ONE)...
then you will get some stuff displaying for the countdown.. and not for the clock.
No?
