Notifications
Clear all

Pcb

19 Posts
10 Users
0 Reactions
8,619 Views
budude
Posts: 10400
(@budude)
Illustrious Member
Joined: 18 years ago
soakes94 wrote:I doubt it, ive bought a piece of hard board and drilled all the holes in it, and glued my leds in, i just dont know how to solder them, have i done it differently than everyone else?

If you're going to do it the "old school" way, there's a post by the guy that designed the thing, Robert Jordan (aka RJ) from the old ComputerChristmas forum - http://computerchristmas.com/christmas/link-how_to/HowToId-112/Ledtriks_Led_Panel . Hope this gives you some ideas.

Nothing wrong with the way you're doing it - quite a bit more work but some folks like the bigger panels. Frank's panels (I'm about to finish up my 12th and last panel) are 1/2" centers so it makes for a bit smaller display but a bit easier to manage with multiple panel sets.


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Just want to check something else about the led board, where do I put the resistors and what rating should I use?

Thanks Stephen


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

Stephen,
When I built my trix panel I found I referenced Kevin's site a fair amount. He has excellent photos and pulls together most of the information needed to build a Triks panel using Pegboard.
If you haven't already, point your browser at: http://www.c3inet.com/LEDTriks/index.htm


Reply
Posts: 393
Topic starter
(@soakes94)
Honorable Member
Joined: 18 years ago

Im using the leds from best of hong kong, can someone tell me also how do I solder my leds together? Is like + to - or - to -?

Thanks Stephen


Reply
Page 4 / 4
Share: