LTC Data problems
 
Notifications
Clear all

LTC Data problems

6 Posts
3 Users
0 Reactions
2,635 Views
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago
[#6916]

I am trying to setup the LTC Data file up. I have two options right now that I want to pursue: COM1 and COM2. When I initially ran the program it did pick up both COM1 and COM2, but when I tried to specify COM2, which I type as " 'COM2:' " as per the direction I got an error stating that the COM port was not open. Could this be because I don't have the Triks-C hooked up, or don't have a Ledtriks sequence in as of yet? I put the LTC09 in the sequence folder like I read. I am scratching my head here. It's probably something easily overlooked.


5 Replies
TimW
Posts: 554
 TimW
(@timw)
Honorable Member
Joined: 19 years ago

Are you typing it as COM2: or 'COM2:' ? Just COM2: ought to do it...


Reply
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

I will try to give that a shot tonight. Thanks Tim. I don't know if I will be able to get to the project any time for the next three or so months. My wife will be going in for a C-section tomorrow. I tried to finish up my enclosure for the LED display, hopefully I can finalize it and get some plexiglass in.


Reply
Penfold
Posts: 1235
Topic starter
(@penfold)
Noble Member
Joined: 19 years ago

It worked! Thanks Tim!

If I wanted to run the a LED sequence I would leave the jumper off the board completely for the first panel correct?

If I want to put a message in stand alone "Tune your radio to 105.3" For instance, I would put the jumper on Pin as follows:

00
XX
00
00

Do I need to burn the stand alone message onto the chip? I have finally bought the AVR programmer from Adafruit and assembled it (I also have AVRDUDE up and running from what I can tell), but have not tried to program anything as the chips that came from the 1st Trik-C Group Buy were preprogrammed.

Please help me understand this whole process as my balding scalp is becoming worse.


Reply
klanger
Posts: 739
(@klanger)
Prominent Member
Joined: 20 years ago
Penfold wrote:

Please help me understand this whole process as my balding scalp is becoming worse.

Put down the gun and back away from the LTC:)


Reply
TimW
Posts: 554
 TimW
(@timw)
Honorable Member
Joined: 19 years ago

The stand alone mode requires a jumper on position 2 of JP6 - I think you have that right - check it on the board.

On the standard firmware the stand alone mode just cycles through the test pattern - a combination of diagonal and blocks that helps test the leds. If you're seeing that pattern you've put it in stand alone mode.

Yes the pattern itself is burnt into the chip with the program. So to change it you need to edit the .asm file, recompile it into a .hex file and burn the .hex file to the chip.

See Here for some bits and pieces nromanel put together that might help.

If that's getting a bit murky, I'm sure someone can make the changes to the file for you to get it up and running. PM me if you're stuck.

Tim


Reply
Share: