LEDTRIKS Panel Cons...
 
Notifications
Clear all

LEDTRIKS Panel Construction Help

6 Posts
3 Users
0 Reactions
2,978 Views
Posts: 56
Topic starter
(@jwells)
Trusted Member
Joined: 19 years ago
[#5281]

I am looking for ideas on building my panel. I am going to start out with just the 1 panel 16X48 and build up from there. I "finally" got my LED's yesterday and I am picking up the peg board (smaller holes) today. I can build a frame out of wood but not sure how everyone else has done it to make it water tight . Does everyone use plexi glass on the front ? I am just looking for some examples to follow.

Thanks

Jim


5 Replies
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 20 years ago

I dont have many pictures of the frame but look here http://www.putfile.com/album/172682


Reply
Posts: 56
Topic starter
(@jwells)
Trusted Member
Joined: 19 years ago

Thanks Ron it looks like you used hot glue and possibly something else to cover the led connections on the back one of the pics looks almost like some sort of clear sheet of mylar ? So did you just use silicone sealer around the joints etc to seal it ?


Reply
kmc123
Posts: 824
(@kmc123)
Prominent Member
Joined: 19 years ago

I've got a few pics here:
http://www.c3inet.com/LEDTriks/index.htm
I hope it helps!


Reply
Posts: 1062
 Ronp
(@ronp)
Noble Member
Joined: 20 years ago

1/4 inch plexi will work just be carefull it scraches easy
Clear silicone sealer is you freind make sure you paint first.
also the hot glue was my first build not realy needed I kinda went overboard lol.


Reply
Posts: 56
Topic starter
(@jwells)
Trusted Member
Joined: 19 years ago

Thanks Ron and Kevin for the pics and feedback. Did either of you paint or seal the peg board I was thinking I need to paint the front flat back then paint some sealer on the whole piece before I start adding the LED's in. The sealer might be overkill just know peg board swells when it gets wet and not sure how much moisture leaks in being outside for many weeks

Jim


Reply
Share: