uzelessknowledge wrote:Used a jig to drill the holes.
![]()
I realize this is almost two years old but how did this Jig work exactly? Did the J channel sit between the verticles and then the post was used as a guide? Was anything "inside" the J-channel to support it as you drilled downward?
The J channel does slide between the vertical sides of the jig on the inside part of the jig. Once you have drilled your first hole, that hole in the J channel is set down on the post so the channel is flat and you drill your second hole. You keep moving the J channel across the jig drilling hole after hole placing the most currently drilled hole on the post. This insures that the distance between holes are the same distance apart. If I remember right, there might even be a video on the site somewhere. I'll check my files for other photos of this as I save as much as I can. Also, check Matt Johnson's web site. He had some videos on building display items and I think he touches on drilling pvc pipe instead of J channel but the process is the same. Search youtube for "Johnson Family Christmas". I hope this helps.
Here's the link to Matt's matrix video:
I think you'll find this very helpful.
FishKing
FishKing wrote:Here's the link to Matt's matrix video:I think you'll find this very helpful.
FishKing
I've watched Matt's videos probably 100x. I think he just does PVC pipe in his jigs no? Rewatching to make sure I'm not missing the obvious 🙂 I was wondering how uselessknowledge was using the pictured Jig with J-channel since in all of my efforts I've put the piece of wood "into" the J channel itself and then drilled through the 5/8" side of the channel (bottom of the J) and into the top of my wood jig. The photographed jig shows a dowel rod between two pieces of wood and I wasn't quite sure how that was working with J-channel drilling. I'm still confused honestly, but since I posted that I've gone into the basement and made a Jig that made some pretty successful holes.
Is everyone drilling exactly 1/2" ? I'm finding my nodes just barely latch into that hole and was wondering if I should go just a little smaller or if it wasn't worth the effort.
jbourne wrote:I've watched Matt's videos probably 100x. I think he just does PVC pipe in his jigs no? Rewatching to make sure I'm not missing the obvious 🙂 I was wondering how uselessknowledge was using the pictured Jig with J-channel since in all of my efforts I've put the piece of wood "into" the J channel itself and then drilled through the 5/8" side of the channel (bottom of the J) and into the top of my wood jig. The photographed jig shows a dowel rod between two pieces of wood and I wasn't quite sure how that was working with J-channel drilling. I'm still confused honestly, but since I posted that I've gone into the basement and made a Jig that made some pretty successful holes.Is everyone drilling exactly 1/2" ? I'm finding my nodes just barely latch into that hole and was wondering if I should go just a little smaller or if it wasn't worth the effort.
Myself, I like to drill a hole a little smaller in size.
