ws2811 mounting
 
Notifications
Clear all

ws2811 mounting

36 Posts
16 Users
0 Reactions
47.6 K Views
Ronnie
Posts: 206
(@ronnie)
Reputable Member
Joined: 11 years ago
Trioxide wrote:Thanks for the idea of the J-Channel. I picked some up and it works great on my rain gutters. I turned it so the curve in the J hooks on to the gutter. Now I just need to attach my pixel strip to it with the zipties and I will be good to go.
Not built yet but this is an idea of what it will look like.

The J hook does work nicely on the gutter. I actually cut some pieces about 2 1/2 inches in length and zip tied them to 1/2 inch pvc pipe every 2 feet or so, then I zip tied my strips to the pvc. The j channel also works well in sliding under the shingles going up the pitch on the side of my house. Just had to turn it the other way as pictured below.

j channel

Reply
stallionent
Posts: 1460
(@stallionent)
Noble Member
Joined: 13 years ago

Strips fit 1/2" rope light channels

$T2eC16V,!w0E9szNZI (BRguJ14stg~~60 57

Reply
Posts: 28
(@tcraft29)
Eminent Member
Joined: 13 years ago

Thank you for posting these ideas. I may try the j channel option. It would make my wife happy to not see wires.


Reply
Posts: 107
(@g8rfn)
Estimable Member
Joined: 17 years ago

Bumping from a LONG time ago... But, has anyone tried a similar method but mounting them in the REAR soffit channel instead (the edge closest to house instead of right under gutter)? If I am understanding what was done here... i think that means you would only need 1 piece of j channel for each section and it would be easy to slide right out and repair / replace any bad wires / bullet nodes in the future. I'm more just wondering what the lighting effect itself would look like along the back edge, instead of the front?

Last q, anyone know of a source where i can get wider spacing on a string of 2811 nodes? I really like the sort of older school look of an individual bulb instead of the "blended lines of light" look. To get that though... I think I'd need 5 or 6 inches between bulbs? Would also be a bit cheaper, i'd hope. 🙂

Thanks in advance for any info.


Reply
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Ray Wu makes custom spaced nodes.

As for mounting at the back of the soffet: Many of us turn down the intensity of the Nodes along the front edge. I would assume you could just use them at a higher setting. It would also depend on viewing angle. If your viewers are lower than the roof line (looking up at your house) then I would think there would be minimal drawbacks to this mounting. If people are viewing from up a hill (looking down on your house) then it might not be good place to mount them. The only other consideration would be reflection from the soffet. Although that might be considered a plus.


Reply
Page 6 / 8
Share: