I bought M6 sealed LED strings. A red LED on one of the strings comes on a few seconds after applying power, then goes back off some seconds later. It comes on and back off a few times then stays off. I don't know if the there is a loose connection inside or what is going on. Has anyone tried to repair a socket/LED in in this type of string? Wondering if I can cut into it and find the problem and salvage it?
It would be a pain to take the string off the wire frame as I used ty-raps and electrical tape to attach it, and send it back for a replacement. I suppose I could cut a socket from another string and solder it in the place of this bad one. Then I would have a 49 count string.
You can
1. Just cut it out and by-pass it.
2. Cut it out and replace it with a bulb from a different strand.
If you choose to replace the bulb please remember that different color LEDs draw different amounts of current so you should try and replace with the same color if possible.
Also (at least to my small understanding) removing lights does increase the overall resistance to to other bulbs in the string so you should probably not remove more than one or two sockets.
The led continues to go on and off depending on how I hold it with my fingers. I guess I'll rob one from another string and solder it in.
While we are on this subject. I need to shorten a blue, green and white string so they will fit the wire frame accordingly. The wire frame is 4 different size stars .
The largest using red LEDs worked out just fine, other than one LED is intermittent. It took two 50 count strings for the largest star. Now the second star will be Blue. It will take a 50 count string plus 29 more from another string. All the strings I'm using are full wave. The Blue string has a blob at the beginning, a blob in the middle and a blob at the end.
I cut the string after the middle blob between the 4th & 5th LED and measured 17milliamps. There are three wires leaving the middle blob. One wire feeds the LEDS that are in series and that same wire after it leaves the last LED in the end of the string is connected to the last blob at the end, the other two are connected to the blob at the end of the string also.
After I measured the current I cut the other two wires and temporarily wired in a 50k ohm pot in series with my meter and the wire coming out of the LED that I cut previously. That leaves the other two wires not connected and dangling. I power up the string. All the LEDs between the 1st blob and the middle blob light up.
I connect the other side of the meter to one of the dangling wires. The four LEDs after the middle blob come on dimly. I adjust the potentiometer while watching the meter. The meter reads about 2ma and the four LEDs go off and stay off even when I reset the pot back to the start position.
I thought reducing the string length was going to be easier than this. I'm at the point of what do I do now to get those four LEDs to come on and be as bright as the ones between the first and second blob.
