jchuchla wrote:Great schematics. I spent some time last year trying to figure this out for some CDI 100ct strings. I believe you said you had these same strings. Did you actually figure it out which of your schematics they use?
I got reasonably close to the same schematic by probing with the DMM. I didn't go as far as you in documenting it though. I did not discover if they used a resistor in the strand. Did you determine that they in fact have a resistor in there, and in which configuration?
After cutting one string, I kept two sections intact and working. This effectively abandoned half of one rectifier. And with the remaining section. I ended up replacing one blob with a half populated full wave converter pcb. It worked and continues to work. But I did not include a resistor. Either I got lucky and the remaining original blob had the whole resistor in there, or it's not necessary to use one.
I have cut 5 CDI strings: three multis and two whites, to make 9 multis and 6 whites. They definitely split the bridge, and they have a resistor - but I was being pragmatic at the time. I simply measured the A/C current in a string-section, and adjust the resistance afterwards to get the same current.
The multis were actually originally two sections, so after shortening, I had to add resistance even though I still had an original blob on one end or the other. The necessary resistance of the string-section that had no original blobs was higher than what I added in the others, so it would imply that there is resistance in the blobs, but since the LEDs were sealed, I did not bother to try to measure it. (I also did not cut them apart too close to the blobs - with only 3"of wire to work with, I wanted to have a "few mistakes worth" of wire available...)
Sadly I did not draw up my schematic diagrams until AFTER I completed that process. I would have cut a few apart differently and would have also been able to verify any resistance in each blob. Externally I could not/did not find an markings in those CDI blobs to see if there were the same or different.
I don't see how there could be NO resistor in there.
Jimboha
It looks like I did leave some notes about the CDI resistances. I found it but am still trying to interpret what I said...
Jimboha
Great diagrmas posted here. My question is:
Lets say you have a 70 count sealed led string with a blob at the beginnings of the string and one at the end and three wires running all the way through especially between the 35 / 36 count mark. Can you still modify the string to 2) 35 count strings instead of 1) 70 count strand. Its hard to find 35 count strings, but its what I need for some parts of my display.
morelights wrote:Great diagrmas posted here. My question is:Lets say you have a 70 count sealed led string with a blob at the beginnings of the string and one at the end and three wires running all the way through especially between the 35 / 36 count mark. Can you still modify the string to 2) 35 count strings instead of 1) 70 count strand. Its hard to find 35 count strings, but its what I need for some parts of my display.
You can modify ANY string, it just depends on how much cutting/splicing you want to do....
With a blob only on each end, I would guess the string uses a voltage doubling circuit, like Todd's did. (Even 70 red LEDs would require more than 120 v.) The best way to split that string into two 35 ct strings is to remove the blobs entirely, cut the string in half, and put a full-wave (bridge) rectifier on each 35ct half. You'd want to measure the current somehow FIRST so you can adjust the new resistance to achieve the same current.
If you want to have end-to-end connection (with a female plug on the other end), I could also explain to you how to split the bridge into two blobs, one on each end. Actually, if you look at my diagrams, you should be able to figure it out (my diagrams assume you'll have multiple 'sections' but you will only want one section.)
Jimboha
