New LED strips
 
Notifications
Clear all

New LED strips

5 Posts
3 Users
0 Reactions
5,761 Views
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
[#51552]

My 3 arches took a dump and I had to order new pixel strips. I ordered the ones posted here and I'm only using 28 pixels for each arch. I'm using that 2" PEX type for arches and even at 28 pixels they look good. However, I have 3 arches, so each arch being 28 pixels that's a total of 84 pixels. On the pixel package it says "The LED strips must not exceed 5 meters when used in a DC series circuit." Does that mean I have to use 3 separate controller outputs Or can I just hook all 3 together using one controller output?
https://www.amazon.com/ALITOVE-Addressable-Programmable-Waterproof-Self-Adhesive/dp/B07M5KPBJM

Sent from my SM-T710 using Tapatalk


4 Replies
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

They say that because you need to power inject and that is the max strip length without power injection. Wire them in a single string, use a single port on the controller and Inject power at the start of each arch and all will be fine.


Reply
pmiller
Posts: 2795
Topic starter
(@pmiller)
Famed Member
Joined: 12 years ago
MartinMueller2003 wrote:They say that because you need to power inject and that is the max strip length without power injection. Wire them in a single string, use a single port on the controller and Inject power at the start of each arch and all will be fine.

I was going to inject anyway even for 84 pixels. I run my strips at 25%. Thank you.

Sent from my SM-T710 using Tapatalk


Reply
Posts: 4
(@feenix566)
Active Member
Joined: 7 years ago

I have the same strips. They're addressable in three-pixel segments. So while you only have 50 nodes per strip, that actually gives you 150 pixels per strip. So if you only need 84 pixels you shouldn't need more than one strip.


Reply
MartinMueller2003
Posts: 7615
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago
Feenix566 wrote:I have the same strips. They're addressable in three-pixel segments. So while you only have 50 nodes per strip, that actually gives you 150 pixels per strip. So if you only need 84 pixels you shouldn't need more than one strip.

Slight terminology correction: You have 50 pixels per strip and three tri-color (aka rgb) leds per pixel. Also known as 3:1 pixel strips.


Reply
Share: