I know im crazy but we just moved into a new house and really wanted to get the roof outline done. Ran a MegaTree last year and loved it. So got the lights all mounted and mostly tested. Tonight when i went to finish connecting everything on the left side of the house i have a connection where i think i might need to power inject so left it unconnected for now. Connected them together without power injection and went to test. Noticed that the bulb right before the end of that string is not working. When connected the next string also doesnt work. Turned it on solid white and am getting no flickering or anything. Tried to measure with a volt meter but number is all over the place and cant get a good reading. Hoping someone with more experience can help me out.
Running Falcon F16v3 controller
Pixabulb lights
350W power supply
12g wiring from PS to Falcon.
50% brightness
Using only 2 ports from the falcon. One for Left side and one for right side of house.
Non working bulb is right at about 100 nodes in.
Thanks in advance
There is a real good chance that the pixel just before the one that is white has gone bad. Think of pixels like this the signal is sent to the first then it passes on to the next pixel and so on. So the pixel that receives the info doesn't pass along the info for the next pixel may cause it to go all white, or anything or not on at all. Hope this helps
Thats what im afraid of. I tested all the strings individually before i mounted them and everything tested fine. Hoping im just overlooking something.
you could just cut out that pixel and jumper over to your next strand. That it should get you up and running, Unless you are changing to a different model I don't think it will be noticed.
Thats what it was. The last node on the string was bad. Cut it out and spliced the last working one to the next string and it worked. Now gotta replace it with another so im not skipping a node and i should hopefully be good.
