Full wave string bl...
 
Notifications
Clear all

Full wave string blob question

14 Posts
4 Users
0 Reactions
4,221 Views
TMerk
Posts: 204
Topic starter
(@tmerk)
Reputable Member
Joined: 12 years ago
[#40233]

I bought used full wave C6 100ct blue LED strings to use on my fishing pond.

IMG 5890

They've been giving me problems since set up. I think I now know why.....the rain! I would just replace the sets that were blowing fuses with other ones to get me through the season. After tons of rain and replacing many sets I finally started to diagnose the problem. Using the led keeper, I began on the first set and found 17 bulbs were bad! I started replacing bulbs with a donor set, replaced the fuse in the plug and they popped in a about a second or less. Hmmm, I then smelled the blobs and sure enough the last blob smelled like roasted electronics! After peeling away the blob(major pita) I found what appears to be a burned resistor, a diode, two more resistors and a capacitor. There's a blob on each end, and these strings look similar to new ones I bought from HLE.

IMG 3787

After reading many posts on converting to full wave(which I have converted many) and resistors, I haven't found one yet that explains how the good quality sets are wired. All 100 bulbs seem to have the same DC wire going through them(there is no 2 wire section). I'd like to repair these strings and even shorten some. I have the full wave converter and string shortener boards from the GB. Hopefully I can use them or it to accomplish this. Any help and/or diagrams would be greatly appreciated! Thanks, Todd


13 Replies
Posts: 582
(@jimboha)
Honorable Member
Joined: 12 years ago

I just posted these the other day. These schematics don't show every possible combination possible, but should give you a god start on figuring out your combination of components in the full-wave bridge of your LED string.

Full-wave LED schematics

Let me know if you still can't figure it out.

Jimboha

Note: My CDI full-wave strings follow one of these patterns, and I have shortened, lengthened and cut apart sections successfully.


Reply
TMerk
Posts: 204
Topic starter
(@tmerk)
Reputable Member
Joined: 12 years ago

I am studying your schematics. It seems as though there is a resistor to drain the cap also. I wouldn't need the cap would I? I remember reading that here somewhere.


Reply
Posts: 582
(@jimboha)
Honorable Member
Joined: 12 years ago
TMerk wrote:I am studying your schematics. It seems as though there is a resistor to drain the cap also. I wouldn't need the cap would I? I remember reading that here somewhere.

I was actually just noticing that. The cap is missing it's plastic cover/wrap, but at first I though there were two diodes. But the metal cap (just 'cap', not 'capacitor' in that charred end does belong to a resistor.

Mostly likely, yes. The cap is there to smooth out the humps after rectification - but it also adversely affects our ability to dim the set. Try it without the cap (and its bleeder resistor) - I am most certain that you won't need it.

I can't quite make out the white lettering, but I do see a pair of holes for the other diode - did it disintegrate completely?

Other than the cap and its bleeder, does what you see match (one of) the schematics?

Jimboha


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

The blob on the CDI strings is a voltage doubler circuit, which is why the strings are 100 bulbs in length. You will probably want to cut the strings in half, and use a more conventional type of rectification.


Reply
Page 1 / 3
Share: