I just purchased some dongles that are rectifiers to change half wave to full wave LEDs. There are LEDs from Walgreens over the past few years. I know you have to change out the wires when it goes from 3 to 2 wires. My issue is that it is a string of 50. It never goes to 3 in the socket until the last LED on the string. And honestly, put it on a LOR controller and tried dimming it. It never flickered. The dimming wasn't 100%, took a little bit for it to start dimming, but it did dim ok after that with no flicker.
Bottom line, I don't think it is full wave and would like to convert it. Do I go all the way to the end of the string and switch out those wires?
Try plugging the male into the female the other way. That is, rotate the male plug 180 degrees and reinsert. if polarized plugs prevent you, temporarily use an adapter. If the string is half-wave, and the dongle rectifier is working, I'd expect the LEDs to NOT light at all - rotate back around, and lights. This would confirm that your 50 count string only has one half-wave section and that your dongle is rectifying to full-wave behavior.
I don't know why you wouldn't see much dimming - though my experience is hat the LEDs stay fairly bright a good way down the dimming curve.
Jimboha
I tried the full wave converter and each time I plugged the lights in the fuse blew. I also tried it on 2 strings I soldered together into one string and some lights wouldn't come on. When I took the converter off the lights that didn't come on had to be replaced. From what I can tell the problem begins with the light with the shunt. Never could get those 5-6 lights to ever come on.
Sent from my Nexus 7 using Tapatalk
jimboha wrote:Try plugging the male into the female the other way. That is, rotate the male plug 180 degrees and reinsert. if polarized plugs prevent you, temporarily use an adapter. If the string is half-wave, and the dongle rectifier is working, I'd expect the LEDs to NOT light at all - rotate back around, and lights. This would confirm that your 50 count string only has one half-wave section and that your dongle is rectifying to full-wave behavior.I don't know why you wouldn't see much dimming - though my experience is hat the LEDs stay fairly bright a good way down the dimming curve.
Jimboha
Ok. I think you just made my day if I am following you. I plugged it in one way, no lights at all. I plugged in the other, all the lights came on. Half wave and it is working correctly??? I am including a pic of the string itself. No "Blob" of any sort on the string.
What do you think?
Sometimes there isn't a "blob" and they will put the resistor in the male plug end
Will these converters work to fix a full wave string where half the string has went dead? I have a few commercial grade strings where 1/2 the strings are dead and I'm assuming it's the blob that is bad.

