looking for ideas!
I want to DIY or build lighted frames to fit my exterior windows. I'm thinking a rigid frame that will friction fit. My windows are brick surround so no screws or anchors.
I'm very handy with wood, metal and fiberglass so all options are on the table.
So I'm looking for a low cost design that can be used multiple years, easy to install, and easily stored.
I made some out of PVC pipe that hang on the shutters on either side of our windows. They've lasted 21 years and have been restrung many times. This may be some help...
http://www.diychristmas.org/dirknerkle/howto-window_frames.html
I bought some window screen frame from Home Depot and made frames for each window, then ziptied the lights to them. If I remember correctly it cost about $1 per foot. I'll try to take some photos when I take them down this weekend.
I have an artistic question. Looking for examples and opinions.
I have casement windows, 2 side by side. Some also have a 1/2 round arch on top.
Should I light/frame just the perimeter, each individual window pane and 1/2 round, all out and duplicate the muntin bars, or something else?
MichiganLights wrote:I have an artistic question. Looking for examples and opinions.I have casement windows, 2 side by side. Some also have a 1/2 round arch on top.
Should I light/frame just the perimeter, each individual window pane and 1/2 round, all out and duplicate the muntin bars, or something else?
Exactly. What size pipe are you using? How rigid is it? Is it temperature sensitive? How does it handle wind?
I'm brain storming and I'm looking for something rigid to friction fit inside the brick soldier coarse. My wreaths blow around sometimes so I'm concerned about any light frame doing the same.
Originally I was thinking aluminum extrusion or some sort of hardwood frame. But the cost is making me re-think my plans.
I might have a PVC idea. Might be time to mock something up.
MichiganLights wrote:Exactly. What size pipe are you using? How rigid is it? Is it temperature sensitive? How does it handle wind?I'm brain storming and I'm looking for something rigid to friction fit inside the brick soldier coarse. My wreaths blow around sometimes so I'm concerned about any light frame doing the same.
Originally I was thinking aluminum extrusion or some sort of hardwood frame. But the cost is making me re-think my plans.
Of
I might have a PVC idea. Might be time to mock something up.
Lightman's pictures look just like what you need. The frames I made were out of 3/4" PVC, I made them about 21 years ago. Mine are fastened to wood trim around the windows with pipe clamps, which wouldn't work for you. Friction fit would probably work, but you could also add a couple strips of industrial Velcro that wouldn't be visible at all and would do a good job of securing them.
I'd love to see these pictures. I want to frame a few windows and want something smaller than PVC to create the frames. Screen frames sounds like a nice approach but perhaps a bit flimsy. Are they stiff/tough enough?
1-1/2 sreen frame base, posted pictures..
Home depot, order only (in my location)
| 100065822 | 731677150001 | 1-1/2 in. Porch Screening System Base Strip |
Tory




