Notifications
Clear all

Overlay effects

6 Posts
2 Users
0 Reactions
1,785 Views
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago
[#24418]

Are overlay effects no longer possible?

From the previous getting started manual, it looks like to do these:

1. Select a group of channels.
2. Right-click -> Modify this effect.
3. Select an effect to apply.
4. Click ok and effects are now hashed with the overlay.

Is this now handled with the master lighting channel? And does that mean overlays are now limited to ramp up/down?

If I'm misunderstanding, how the heck do I do overlays?


5 Replies
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

Overlay were just Ramp UP/Down applied on top of a channel/channels.

The Sub-MasterLighting Channel does the same thing but makes things much easier process.

Remember --- Master Lighting --- channels that control ALL display channels.

Sub-MasterLighting ---- think Segment with assigned channels --- lighting control over only THOSE channels. You can have as many as you need.

Joe


Reply
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago

Ok. Thanks Joe for clearing that up.
And I answered my own question about having them be active.


Reply
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago

Ok, new question:

Lets say I'm using Submaster lighting channels to fade in and fade out pixelplane effects.

So, I have the channel active, and I apply a ramp up at the beginning of an effect and a ramp down at the end of the effect. Do I need to place a Level effect in between the ramps to make that effect "live" after the ramp up has ended? Or, do submaster lighting channels ONLY affect lighting where they actually contain effect data? So, a 100% off grid cell in the lighting channel would mean the channels it controls would run their effect normally...?


Reply
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

You got it.

ONLY effects that have intensities greater than Zero are applied.

So ... if there are no effects on the Lighting Channel --- the associated channels are not affected.

If there are effects --- the channel's lighting is based on it's effect AND the effect from the Lighting Channel.

Joe


Reply
jlowe
Posts: 952
Topic starter
(@jlowe)
Noble Member
Joined: 16 years ago
JHinkle wrote:You got it.

ONLY effects that have intensities greater than Zero are applied.

So ... if there are no effects on the Lighting Channel --- the associated channels are not affected.

If there are effects --- the channel's lighting is based on it's effect AND the effect from the Lighting Channel.

Joe

Gotcha. Thanks for the clarification.


Reply
Share: