ENTTEC PRO problems...
 
Notifications
Clear all

ENTTEC PRO problems with HLS

4 Posts
3 Users
0 Reactions
1,634 Views
Posts: 15
Topic starter
(@svaronalli)
Eminent Member
Joined: 13 years ago
[#25761]

Hi.

I am trying to prepare for next christmas, new experience in light management for holidays but quite familiar with DMX in general due to Light Service experience.

I am trying to use my DMX PRO ENTTEC to connect via HLS.
As known, it's USB board, and mine is original Enttec.

I connect, correctly discover with the HLS Output settings in menu, but it stay down, no led blinking, no signal output.

Card is working fine because of Vixen, Enttec tools, Freestyer dmx and so on are working fine with it on the same pc.
PC is X64 Win 7.

Any ideas?


3 Replies
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

I know you are trying to resolve this. We have had over a dozen PMs on this subject and there are already two other threads addressing this issue for you.

I doubt starting another thread is going to solve your issue - it may only dilute the responses from the members and dely resolution.

As I stated in the last PM to you, I suspect the dll you are using may not be designed for low-level dll communication - only COM based communication. I await your resply to the PM.

In the meantime, I request you do not use this thread and use the othere two active threads to help resolve your issue.

Joe


Reply
Posts: 1
(@zebulon)
New Member
Joined: 13 years ago

Hello, sorry to reactivate this thread, but i have the same problem and i can't see a solution in this forum. I use the CDM 2.08.30 WHQL driver and set: load VCP in USB Serial Converter (in hardware manager).
Then i set the same stop bits and baud rate as in HLS 14S Setup Com Ports. I tried in transport type both the com and the USB-DMX but without success. When i test manually to turn on and off the lights in HLS 14S the green led of my
original Enttec DMXUSB Pro is not blinking. (What means that the Enttec Pro is not in transmitting mode. see API of it) With Vixen3 i also have no success. But with Freestyler the Enttec Pro is working. Can anybody help me? Thanks.
Erik


Reply
Posts: 3650
(@jhinkle)
Famed Member
Joined: 15 years ago

Check out the other thread on this topic.

The "Real Entec Pro" was added via the COM port interface.

The other user demonstrated that it worked - although he had some issue getting Windows to properly recognize it.

It appears you must only use COM if you have a real Entec Pro -- they are particular.

The Entec Pro clones work great --- use the dll interface with them.

Good Luck.

Joe


Reply
Share: