Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

I did a quick test sequence in vixen 2. I made a test sequence in vixen 3 and used teberle's virtual helix controller to export it, but I couldn't make it work. The file was not readable by helix or vixen 2. I've emailed teberle about the problem and am really hoping he can fix it. I'm starting from scratch sequencing and vixen 3 would be a real time saver. I haven't found any usable vixen 2 sequences that I could just patch in my pixel tree and pixel arches.


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

Thanks. It seems like using Vixen 2.x would be difficult for pixels.

I'm assuming you need to use 3 channels for each pixel light?

Time to research more but if that is true


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago
blantrip wrote:Thanks. It seems like using Vixen 2.x would be difficult for pixels.

I'm assuming you need to use 3 channels for each pixel light?

Time to research more but if that is true

Sorry hit the send button on my iPhone...

...if that is true I would need 300 channels programmed in Vixen 2.x for a 100 pixel string. I'm going to need a larger monitor so I can see at least a good portion of those 🙂


Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

That is correct, you need 3 channels per pixel.


Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

Just a quick pointer to keep in mind when sequencing for the ethernode....
1. Make sure you end every sequence with the pixels off on the last frame. The pixels will hold their last command when the sequence stops.
2. When building the show in Helix, place a 5 second pause between each sequence and after the last one. If you don't the ethernode won't have time to reset and will stop after the first sequence.


Reply
Page 6 / 22
Share: