Helix Ether-Node Co...
 
Notifications
Clear all

Helix Ether-Node Controller

108 Posts
8 Users
0 Reactions
73.4 K Views
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

I just got through playing a test sequence with my helix / ethernode / E682 setup. Here is my setup:
Helix V3
2 x 32 channel SSR daughter boards
16 channel LOR controller
Ethernode
E682
12 strands of 50 2811 pixels


Reply
Posts: 410
Topic starter
(@gmbartlett)
Honorable Member
Joined: 19 years ago
blantrip wrote:Are you using the SanDevices E682 board with the Ether-Node Controller?

Yes, I used two E682 boards with the current firmware and set for Unicast mode.


Reply
Posts: 191
(@mlevings)
Estimable Member
Joined: 14 years ago

Update: I misunderstood the channel mapping page. I corrected my channel map on the ethernode and my 12 strands are running perfectly.
Thanks Greg!


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

I'm jealous. I'm still building my ether-node board and waiting for my pixels and E682 kit.

I'd love to hear any other info you've learned along the way that could be helpful.

Bryan


Reply
Posts: 373
(@blantrip)
Reputable Member
Joined: 16 years ago

mlevings are you using Vixen 2.x with the ether-node controller? In Greg's post in this forum he discusses Vixen 2.x but I some discussion in the Helix-Vixen3 forum as well about Vixen 3.

Just trying to determine if I should be revising my sequences in Vixen 3, or just keep working in Vixen 2.x.

Thanks,
Bryan


Reply
Page 5 / 22
Share: