Hello!
I'm looking to create a pumpkin patch in my yard using foam pumpkins that I carved. I want to scatter them all over the yard and light them up so that they can all be lit up with different colors or the same colors. I was thinking of using pixels because that seems like what I'm looking to do. At some point, I'd like to create a show but for now I want to start small. Can anybody help me figure what I'd need to do this? I attached a picture of what I'm looking to do.
I'd really appreciate any help!
Thanks.
Matt
Don't forget that you'll need lots of time. Everything takes longer than expected, and halloween is only six weeks from now.
The wiring and power distribution schemes may need to be different from most of the pixel discussions on this site. The reason for this is that the pixels in your pumpkin patch (if it's anything like the photo included above) are going to be hundreds to thousands of cm apart, rather than 10 cm (4") apart as in the usual pixel strings.
Individual pixels run by arduinos are probably the best, but also, just throwing in several LED's on different GPIO's on an arduino would work, too.
I know I am going to get "eaten alive" by this comment, but you could also use Dumb RGB for this particular project since all you are trying to accomplish is change color within a prop.
The one nice thing about dumb RGB modules is that all you need worry about is voltage drop.
This is the reason I still keep a couple 27 channel DMX controllers hanging around as they would work great for something like this.
Or orange tea lights (static or flickering).

