Today, I completed my grinch and SSRs and I'd like to share a few things that may be helpful to others, especialy the newbies.
1. Test/check LEDs first. I had a couple LEDs where the leads were mixed up and caused me to solder them in backwards. (Normally the short lead goes into the square soldering square, but I had 2 from Mouser that were reversed) One can do this with many multimeters and discover the positive/negative side. A easy way without a multimeter is to If you look into the LED itself, you will see a larger half and a smaller half. The larger half side will go into the square hole.
2. The Pin numbers on IC chips and sockets start at the number one and begin on the upper left hand side and increase all the way down. Once at the bottom of the left side, resume counting from the bottom right and work your way up. I myself knew how this worked, but being several years out of the electronics hobby, I forgot if it started in the upper right or left. Some chips have a dot, but the Allegro chips do not, but do have an indentation to indicate the top.
3. If the LEDs are lit up on your Grinch and SSR boards, but they are not switching, try another patch cable, or even two. I could have saved myself a good amount of time by doing this before testing continuity and voltage on nearly every path before realizing my solder joints were not to blame. Power to the LEDs on your SSRs may also stem from this as well. The first two patch cables I used had shorts, but still powered the LEDs.
4. You've confirmed your Grinch and SSRs are good and your connection cable is good too so you take the next step to put in a chip and start up Vixen, but no lights are coming on. Your parallel port is setup right, but you still have no blinky flashy. In the troubleshooting guide, http://www.doityourselfchristmas.com/wiki/index.php?title=Troubleshooting_Guide_%E2%80%93_The_Grinch#Vixen_Data_Problems , you go through the steps, but maybe you're not sure if you're getting a good reading or what, because you're getting voltage reading opposed to zero, but you're not sure how it relates to what's listed in the guide. I myself was getting slightly higher that the 4vdc mentioned at U1 pin2 and my voltage was not fluctuating U1 pin3, but it was steady and in range. I switched out the chip with another one and everything began to work. Either the chip was defective or there was too much static electricity around when I handled them.
I'm sure I ran into a few other things, but these are ones that really stuck out for me as they ended up causing me to spend extra time troubleshooting and searching the internet for info.
Oh yeah, staying up late to finish soldering may impare your judgement, as you get more tired you may make some dumb mistakes and you may not remember what you did for sure the next day. So it is helpful to keep a log and maybe snap some pictures along the way.
