Hi Folks,
Thanks to John W, I received the Grinch and 16 SSROZ boards but have not assembled any until yesterday and today. Reason? Uh, waiting for the IC sockets. Ok pass that part so two "test" SSRs are built and today I solder up the Grinch. I know most of you are saying "Yeah?" (please be kind, it is a mile stone for me :))
Questions: (boring part is over)
1 - I notice that there seems to be extra traces and holes in the Grinch
between D socket and J2, Under Sockets A, E, I, M - Is that ok???
2 - Is there a recommended way to test the Grinch and SSRs before connecting up the 120V AC?
(low voltage? multi-meter, etc - Decided after building this I didn't want to go POP in the night)
I do have my computer ready with the printer port to RJ45 cable plus I have extra Ethernet patch cables from when I network my house. I still need to get 5vdc to power up the Grinch (that should not be a problem taping off the PC power supply (note to self - need inline fuse(s))
One more thing. I USED to think my hands were steady and my eyes were pretty good (only 43 yrs old) but I learn that I need to get a lighted magnified lens before assembling any more boards.
Anywho
Thanks for any advice.
Sorry if this info is already somewhere on the site. I did look through the posts in the Grinch section and didn't see what I was looking for.
Rick R.
I myself find the smoke test to be a very effective means of determining if you built the boards right!!!
Steve
First thing to do before installing the ICs in their sockets on the Grinch is to check that it has a proper 5V. The power LED should be on. Also, pin 1 on J2 (the square pad) is +5V, and pin 2 (the other pad) on J2 is ground.
--
Phil
Always power up without ICs initially. IC smoke is more valuable than other smoke.
Hi rlilly, Phil, Steve
Thanks for the info, Well Phil anyway 🙂
Phil, I am using 5 volts from a former computer PS that I had convert a year ago to power up stuff on my train layout. I double check to be sure it was 5volts and I had the connector (J2) and the wires connected correctly.
With the help from the guys in chat (wombat) they suggested to make a RJ45 cable with 4 leds on the end (I also added in a 180 ohm resistor).
So now I have checked each port on the Grinch and all is well there. 😀
rlilly and Steve - I agree that magic smoke is more fun, at least for those few seconds. But stuff seems to last longer the boring way. Oh well
Thanks again
Rick R.
rrowan wrote:
1 - I notice that there seems to be extra traces and holes in the Grinch
between D socket and J2, Under Sockets A, E, I, M - Is that ok???
Just wondering if anyone has an answer for this question? I'm putting together my grinch at the moment and asking the same myself. Can't seem to find anything in the forums or wiki about it (or maybe I'm blind - it's a possibility).
Cheers!
Those are just vias for routing the signal on the board. Nothing goes in them.
I guess wjohn/RJ put them under the RJ45 jacks so they wouldn't be seen when the board was complete.
So it's a case of just leave them alone and ignore them?
Yes
If you follow the steps in the Grinch assembly wiki then you won't go wrong.
http://doityourselfchristmas.com/wiki/index.php?title=GRINCH_Controller_Assembly_Instructions
Yeah I've been following it and the other grinch info I‘ve found on the wiki (I’ve been franticly reading everything I can!). It's was probably a forehead smacking question, but thanks for your help - really appreciate it.
