Xlights is giving m...
 
Notifications
Clear all

Xlights is giving me errors.

2 Posts
2 Users
0 Reactions
2,017 Views
Posts: 195
Topic starter
(@tommy)
Estimable Member
Joined: 19 years ago
[#33932]

This year's show we have a need to use Xlights to convert sequences created in LOR S3 Advanced to run on a Falcon Pi Player. The FPP will run into a 6-port DMX bridge and from there... DMX out to the controllers.

We have about a dozen 128-channel LOR sequences (expanded out to fill a total of about 300 channels). We want to run these sequences on all of our LOR and Renard Controllers. Our hardware inventory consists of eight 16-channel LOR a/c controllers, six LOR 24-channel DC controllers, and two 24-channel Renard RP TR-24 a/c (flashed with DMX firmware) controllers.

Using LOR S3, I've changed all of the LOR channels to DMX. But Whenever I try to convert the channels to fseq files with Xlights, the first 40 or so channels seem to convert just fine. But when Xlights gets past that, I get "Warning! Channel is not mapped". What am I doing wrong? I'm starting to get very nervous because show time is heading towards me like a speeding freight train.

I hope there are some Xlights & LOR experts out there that can give me some guidance.

Thanks in advance,
Tom


1 Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

If you scroll up to the very top of the status box with all the messages on the convert page, you should see some information about what xLights found in the LMS file. It should tell you the number of DMX universes, number of channels in each, etc.... Make sure your "setup" page in xLights matches that information. If there are 2 DMX networks in the LOR file, you need to have two defined. If the first one has 55 channels, you need to have at LEAST that many channels in the first output for your setup tab.


Reply
Share: