Which effect to use...
 
Notifications
Clear all

Which effect to use?

9 Posts
4 Users
0 Reactions
3,622 Views
Posts: 6
Topic starter
(@thelloyds)
Active Member
Joined: 11 years ago
[#39014]

Good Day Everyone,

I know this question has likely been asked before, but I have searched and can't find the answer. My husband and I are new to the vixen program. We currently have been using Arduino Uno and a frequency program to flash simple LED's on and off to music. And then we found Vixen!!!! :wow: At this point we are simply trying to figure out which effect is best to use to turn the lights on and off, they are not RGB's, but simple plug them in and they come on string LEDs. Can someone help send us in the right direction. We have ordered a couple strings of addressable RGB's, but they might not even make it here for Christmas 😯
Thank you


8 Replies
Posts: 6
Topic starter
(@thelloyds)
Active Member
Joined: 11 years ago

I guess I should tell you all we are using Vixen 3.2


Reply
Posts: 20
(@dcdowden)
Eminent Member
Joined: 12 years ago

You could probably use the alternating effect - you can set the period/frequency of the effect.
Doug


Reply
Posts: 317
(@spyder)
Reputable Member
Joined: 11 years ago

If you wanted to line them up with the beats you could try using the pulse. You can change the ramp up and drop off brightness if your controller/lights support dimming by adjusting the curve.


Reply
Posts: 6
Topic starter
(@thelloyds)
Active Member
Joined: 11 years ago

Thank you for your suggestions, I'm going to give it a shot.


Reply
Page 1 / 2
Share: