Zero Cross?
 
Notifications
Clear all

Zero Cross?

7 Posts
6 Users
0 Reactions
2,647 Views
nromanel
Posts: 147
Topic starter
(@nromanel)
Estimable Member
Joined: 19 years ago
[#3811]

Can someone explain "Zero-Cross"
And it's use/purpose on a Ren24 Board?
Thanks!


6 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

Zero Cross is the reference point where the AC line crosses 'zero' per cycle.


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

Once zero volts is detected, the Renard software waits a period of time and then turns on the TRIAC which then turns on the lights. The period to wait is based on the dimming level that you choose.


Reply
omzig
Posts: 1603
(@omzig)
Noble Member
Joined: 19 years ago

I think that some people are confused about the zero cross jumper on the board. The board has a zero cross detector that is necessary for dimming and is always on, regardless of what the zero cross jumper is set to. The jumper just configures whether or not the controller sends the zero cross signal to the RJ45 for upstream controllers.


Reply
nromanel
Posts: 147
Topic starter
(@nromanel)
Estimable Member
Joined: 19 years ago

That's exactly what I needed to hear!! Thanks Don!!


Reply
Posts: 60
(@jftiger)
Trusted Member
Joined: 19 years ago

What is the reccommended max distance to send the Zero Cross signal?


Reply
Posts: 190
(@vziukas)
Reputable Member
Joined: 19 years ago

You can find about ZC signal and ZC generator (which I'm building for my REN-C) on my website http://www.christmasinallen.com/ZCDetector.aspx


Reply
Share: