Testing renard boar...
 
Notifications
Clear all

Testing renard boards

20 Posts
13 Users
0 Reactions
7,769 Views
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
[#25010]

I was wondering if any of you have built a board tester to wire to the output terminals, instead of having to connect 16 or 24 strings of lights or LEDs to test the board.


19 Replies
FIRECOP252
Posts: 1292
(@firecop252)
Noble Member
Joined: 16 years ago

not sure where it is but someone took a 1x4 and put 24 single lights on it to test channels on boards up to 24 channels and it worked pretty good. Dont know where the thread is but someone else might remember it also. Hope that helps


Reply
Posts: 127
(@s196635)
Estimable Member
Joined: 14 years ago

Find a spare string and cut off the male end. Connect the negative to output 1 and screw it down, run a sequence that turns all channels on at once and with the positive cable go from CH2-16/24 without disconnecting the negative.


Reply
raplass
Posts: 636
(@raplass)
Honorable Member
Joined: 15 years ago

Incan C9s (or C7s) in their original holders is what I use.


Reply
Posts: 18
(@shades67)
Eminent Member
Joined: 15 years ago

Ijust use the metr, setup a sequence that alternates between 4 different settingsand watch the voltages.


Reply
rstehle
Posts: 4348
(@rstehle)
Illustrious Member
Joined: 19 years ago

Just set Vixen to All On and use a DMM to check if each channel on the output terminals has 120v output. Easy Peasy............


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

I just mounted a string of C7’s. A DMM works fine for On/Off but the C7’s showed me twice that I had opto-couplers that didn’t dim correctly around 50% when dimmed slowly.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago

Ok, thanks for all the tips. I was wanting to see all channels respond to a sequence.

I have a string of 5watt incandescents I can cut up and use for a load.


Reply
boyelroy11
Posts: 757
(@boyelroy11)
Prominent Member
Joined: 17 years ago

Here a quick write up on the one I made:

http://williamschristmaslights.com/a-quick-board-tester-build/

Maybe it will give some ideas.
Bruce


Reply
Posts: 321
(@frostbyte25)
Reputable Member
Joined: 15 years ago
raplass wrote:Incan C9s (or C7s) in their original holders is what I use.

Same here .... Drilled 16 15/16" holes in a thin board and they pushed in and held themselves... Then i took all the male ends i cut off the extension cords for my pigtails and re-purposed them.
Ive also have read that people will go buy a bunch of night lights from the dollar store and plug straight into there pigtails....

2013 03 30 14 39 10 893 zps8029bed0

Trav


Reply
Page 1 / 2
Share: