SS24 Issue
 
Notifications
Clear all

SS24 Issue

10 Posts
4 Users
0 Reactions
3,174 Views
Posts: 70
Topic starter
(@cheme)
Trusted Member
Joined: 17 years ago
[#17194]

I'm trying to get the SS24 I built to work. Nothing will light up when I run any sequence. On the board itself, only the power LED is on.
I troubleshooted with a diagnostic PIC and everything works as it should, aside from sequences not running. Channels 2 and 5 blink as they should and channels 6 and 7 are constant on when a sequence is run with the diagnostic PIC. On the board, SD and FE are on when a sequence is running but only with the diagnostic PIC.

My PICs are from the co-op so I assume they are programmed properly. I swapped them out with extra ones I have and I get the same result.
Data comes from USB port COM5 to one of the LOR USB to 485 adapters. Vixen is configured properly, as far as I know.
I've never had a problem like this before but I'd appreciate any ideas to fix this.


9 Replies
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago

If the FE light is on then that is an issue, and must be corrected before it will work.

http://www.doityourselfchristmas.com/wiki/index.php?title=Renard_Firmware#Diagnostic_Firmware


Reply
Posts: 70
Topic starter
(@cheme)
Trusted Member
Joined: 17 years ago
Wayne J wrote:If the FE light is on then that is an issue, and must be corrected before it will work.

http://www.doityourselfchristmas.com/wiki/index.php?title=Renard_Firmware#Diagnostic_Firmware

Well that's great but I went through all available Baud rates and still have the FE on. I tried on my SS16 as well with the same result.

Not sure if it matters but the PICs on the SS16 are with 57600 Baud which I programmed myself. The PICs on the SS24 as well as the Diagnostic PIC were from this year's offsite co-op.


Reply
Mactayl
Posts: 2491
Guest
(@mactayl)
Member
Joined: 17 years ago
ChemE wrote:Data comes from USB port COM5 to one of the LOR USB to 485 adapters. Vixen is configured properly, as far as I know.
I've never had a problem like this before but I'd appreciate any ideas to fix this.

If you are using a LOR USB to 485 adapter pins 4 and 5 on the RJ45 connector are reversed so it will not work unless you swap those pins, maybe I am wrong but that is what I had to do to get my Renard's to work with a LOR USB 485 adapter.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago
Mactayl wrote:If you are using a LOR USB to 485 adapter pins 4 and 5 on the RJ45 connector are reversed so it will not work unless you swap those pins, maybe I am wrong but that is what I had to do to get my Renard's to work with a LOR USB 485 adapter.

I think that's right, I've see comments over the years to the effectthat the LOR equipment has pins 4 and 5 reversed from the Renard setup. Renard has the Data+ on pin 5 and Data- on pin 4, which is backwards from LOR and (presumably) the rest of the world.


Reply
Page 1 / 2
Share: