This is my first year os doing this and I am having some growing pains. I am starting small with just one RenardSS 16 at the moment. I am unable to get it to communicate with my PC(running windows 7 and Vixen software) I assembled the board per the directions in wiki as well as the DE9 to RJ45 connector. The board is only about 30ft from the PC. The only indication on the board itslef is the power light. I have the board selected under my profiles in Vixen. I am hoping that I just made a simple dumb mistake and missed something minor before I start removing things off of the board.
Any ideas/suggestions would be greatly appreciated.
Work your way through the troubleshooting guide.
(ph.. and your PICs *are* programmed... aren't they?)
I believe they are programmed, that was apart of the co-op. I will try the troubleshooting guide when I get home, I was just hoping for something small that I missed.
Thank you so much for your help.
I bought mine in the group buy as well and one of the PICs either was missed in the programming or lost its programming, which can happen. Even with the troubleshooting guide that looks huge it wasn't too bad and i was able to determine that my data cable was good and then figured out the PIC was bad. Even with all the steps it doesn't take too long to go through.
Make sure your data rates are per the wiki specs. Very easy to overlook in both device manager and vixen.
