SS24 Help needed
 
Notifications
Clear all

SS24 Help needed

6 Posts
4 Users
0 Reactions
2,071 Views
Posts: 181
Topic starter
(@mangrove)
Estimable Member
Joined: 16 years ago
[#34400]

I have 25 Renard SS 24 controllers split into two universes. I'm running DMX on all controllers. The first universe works great, no issues. The second universe is the issue.

The first 4 controllers on the second universe work fine but all data stops at the fifth controller. When this happened in the past, I've simply unplugged the controller with the issue and the controller previous, wait about a minute, plug them back in and all worked fine; not this time.

I've tried replacing the CAT5 with known good CAT5 still dead.

It's got to be something with the controller. What sends the data to the next controller? Specially what's responsible to send the data down the road? I replaced the bad controller with a good one; it worked for a while then whammo, the same issue happened. Something is stopping the data dead at controller 5; what could it be?

Environmental; I'm in Southern California and it finally rained hard yesterday. We were dark last night because of the water. All other controllers are dried out and are working fine. Water could be a factor but as I said, I replaced controller 5 with a spare dry controller and I still have the issue.

All help welcome and appreciated.


5 Replies
Reddy_Kilowatt
Posts: 547
(@reddy-kilowatt)
Honorable Member
Joined: 19 years ago

U4, (the RS485 Transmitter IC) could be bad on controller #4.

Or a pin could be out of place on the jack.

-Craig


Reply
Posts: 181
Topic starter
(@mangrove)
Estimable Member
Joined: 16 years ago

Well, I'm not sure what I did, I replaced U4 and unplugged it a bunch of times, and it's working now. I'll test the suspected bad controller and see if I can find anything wrong.

Bottom line the show is up and running now! Thanks for the help!


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

I have 2 px-1 and i worked fine the other didnt work alot of checking later using my magnifier i seen inside my rj45 jack 1 pin was crossed came that way i used a pin too move it into right place and bang up and working hope you figure this out


Reply
Reddy_Kilowatt
Posts: 547
(@reddy-kilowatt)
Honorable Member
Joined: 19 years ago

Glad you got it going.
When you get a chance.. you could also inspect the board for bad solder joints around U4,U5 and the jacks.

-Craig


Reply
Davor
Posts: 221
(@davor)
Reputable Member
Joined: 16 years ago
Mangrove wrote:
Environmental; I'm in Southern California and it finally rained hard yesterday. We were dark last night because of the water. All other controllers are dried out and are working fine.

Are your controllers in weatherproof enclosures? It did rain pretty hard the past few days, but with proper waterproofing, the display can run rain or shine.


Reply
Share: