Not sure if anyone else actually still uses this stuff, but I’ll give it a shot:) I have an Olsen595 with RenC (and RenT for ZC). I’ve been using this for several years with no real issues, including this year for the most part. However, I’ve been troubleshooting an issue with two new sequences for this year. I use this controller specifically to drive C9s - for each rs485 output of the 595 I use 3 of the possible outputs to drive a red string a green string and a white string. I am using only the first 9 rs485 outputs (with three channels in use per each output). In both of the new sequences I have a point in the song where all of the white strings go full on, and at this point the board freezes up and weird things start to happen, like all of the channels coming on (all of the C9 strings come on, all of the led indicators on the 595 come on) and it gets stuck in this state, so I need to reboot the controller. It is repeatable and happens at the same point (I know when it will happen on both songs). I’ve been trying to figure out what’s going on and I do notice a point where the data overrun led on the RenC comes on. I have to believe there are other points in all the other songs in my show when all of the channels associated with white for this controller come on, so it doesn’t seem like I would be sending too much information to the controller. Does anyone have any thoughts about what might cause this, or where I might look to troubleshoot further? Some additional info - I actually noticed this last year on one of these two new sequences, but I didn’t spend any time troubleshooting, as I chalked it up to memory issues with my PC. Last year I was running Vixen 2.1 from an old off network PC. This year I have migrated to a raspberry pi 3B+ and am running FPP v2.4. I am currently running a show with about 7 songs looping that run with no issue using this controller, so it’s clearly related to these specific songs, and in both I’m going to a full white (representing the 3rd channel in each bank of 4).
Sent from my iPad using Tapatalk
