Hello I need some light on my ren 16 like the picture first chip on left is the normal prog with pwm the rigth one is prog with the ren-diag
led 2 and 5 are flashing so i guest i have the zc and the chip running fine
but it doesnt work like no signal from the com on the pin 5 of the pic I have 1.23volt (which is the 485in)on the pin 6 i have 5.0volt (which is the 485 out)
anyone can help me out debuging this one out
Well, I would move the PIC with the Ren-Diag firmware to the left side of the board and see what you get there.
You should get Chan 10 and Chan 13 blinking just like on the right side.
Then send a sequence with something changing every event (why every event? Because data is only sent when something changes) and that should get Chan 14 to light up if all is well. If it doesn't then you need to double check your cable coming from the computer to the Ren16
ok done the swap but still nothing form the signal i know my ren t work i had a ren64 before but is there a way to test the 485 without a scope
shocker wrote:ok done the swap but still nothing form the signal i know my ren t work i had a ren64 before but is there a way to test the 485 without a scope
Do you still have the Ren64? If so, does it still work? You could do a side-by-side comparison since the data reception circuit is the same between the 2 boards.
I'm assuming you have the plug-in setup correctly since you have already been using a Ren64.
I tried an experiment that should work for you to see if data is coming out of your U20 chip.
- Remove U1 (left PIC) and place an LED between pin 1 and pin 5.
- Run you sequence, the LED should flash as data is sent. This doesn't tell you the data is good but it shows that U20 is processing/sending the data.
ok i figure out what was my prob
1. my ground was tie together
2.I use ic isl 8483ip has 485 chip and just found out there half duplex 🙁
i have put in some sn75176ap and it is working fine now
