Question about PIC ...
 
Notifications
Clear all

Question about PIC programmer

10 Posts
7 Users
0 Reactions
4,261 Views
Posts: 125
(@bonuts)
Estimable Member
Joined: 19 years ago

If it means anything to you I think mine arrived in Texas from Canada in less than a week.


Reply
Posts: 339
(@dan-ross)
Reputable Member
Joined: 19 years ago

Mine arrived in less than a week (I ordered on thursday night and had it by wed of the following week) from canada. I haven't run it on a usb to serial to see if it works but it worked fine on my PC with a built in serial.


Reply
grages
Posts: 259
(@grages)
Reputable Member
Joined: 19 years ago
Dan Ross wrote:Mine arrived in less than a week (I ordered on thursday night and had it by wed of the following week) from canada. I haven't run it on a usb to serial to see if it works but it worked fine on my PC with a built in serial.

The JDM wont work with a usb 2 serial interface according to the MCU mall forums.
http://www.mcumall.com/forum/topic.asp?TOPIC_ID=384

Shawn


Reply
Posts: 29
Topic starter
(@wo1vesrx)
Eminent Member
Joined: 19 years ago

Thanks everyone for your replies. I decided to go with the Pickit 1. It was a bit more than I wanted to pay, but it will be shipped priority mail, so I should have it quickly.

I know a couple of you said you got the one from Canada in less than a week, but with Halloween just over a week away, I didn't want to take a risk on it. Besides, I'd rather have the few extra days to diagnose any errors in my hardware.

Thanks again everyone!

Brian


Reply
Posts: 555
(@zaker)
Honorable Member
Joined: 19 years ago

PIC programmer

Futurlec.com has one for $59

http://www.futurlec.com/PIC_Programmer.shtml

I just ordered one of those.

tom

UPDATE: Just got this programmer, it is a PICKIT2 clone, programmed right in MPLAB, took 10 mins to figure it out and program the diagnostic code for my Ren64 😀


Reply
Page 2 / 2
Share: