programming a PX-1
 
Notifications
Clear all

programming a PX-1

13 Posts
6 Users
0 Reactions
4,185 Views
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago
[#45337]

I am having trouble programming my PX-1. Previously I would use the option to run a sequence through vixen to reprogram certain settings.
However last year I was unable to get any of my PX-1s to accept the new settings. Even scaled back my display so I could use one of the PX-1s that was already programed like I needed to use on a new prop.

Last year I had to re-install vixen on my show computer. I am using windows XP on an older computer, and vixen 2.1. I know that sounds like the dark ages, but I am cheap, and my display has a limited amount of animation. And, I was able to run vixen on the computer after a couple of re-installs of vixen for the Christmas season.

Yesterday I ran a sequence that controlled some lights, went back changed the sequence to re-program the PX-1 and it would not accept it.

I have tried everything I can think of, and have had no luck as of yet.

No matter how obvious it seems if anyone has an idea let me know.

I did use the 0-255 intensity levels to set up my sequence, and checked the port settings on the sequence and com ports.

As I have made those mistakes before

Frustrating when things do not work like they are suppose to.

And I don't know that I want to spend the money to replace my equipment and buy new pixel controllers for the limited animation I have in the display.

All suggestions are welcomed.

bert-nc


12 Replies
Aurbo99
Posts: 2803
(@aurbo99)
Famed Member
Joined: 19 years ago

similar issues fr me last year.

I went back to V2.1 to re-program.

after a few days of tearing out my hair..

I realized I was setting my baud rate too high to program (as opposed to the set baud rate your programming on the PX1)

Set the V2 Renard controller speed to 9600, set the 6 intensity levels as per the wiki.. program..


Reply
MartinMueller2003
Posts: 7612
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

The suggestion to look at your baud rate is a good one. If that does not work then just modify the defaults in the code and reprogram the PIC (I assume you did that when you initially built the PX-1). In case you got the chips pre-programmed, I am sure someone on the forum would reprogram them for you.


Reply
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago

The suggestion to set the port settings to 9600 did not work

the pics where programmed when I got them.

I have tried to reprogram three different PX-1s with no luck

I would not think that all pics for some reason would need to be reprogramed. However I do not know and if you think that is the problem I will go that route.

thanks in advance

bert-nc


Reply
Posts: 1168
(@keith-r)
Noble Member
Joined: 19 years ago

I think what aurbo99 is saying Is correct. You need to program the chips using the original code, then change your baud rate and color order in the tool that is in one of the threads. You then change your port to the new baud rate and you should be good to go.


Reply
Page 1 / 3
Share: