programming a PX-1
 
Notifications
Clear all

programming a PX-1

13 Posts
6 Users
0 Reactions
4,196 Views
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

most likely the issue is the baud rate and / or making sure the programming jumper is in place. You might also try 56Kbps as the baudrate since that is the default baudrate. I am pretty sure the wiki has instructions for using the programming utility. I personally never used it because I burn mine using the picKit3.


Reply
Aurbo99
Posts: 2804
(@aurbo99)
Famed Member
Joined: 19 years ago

Its the baud rate on the Vixen2 Renard plugin.. set it to 9600 (or whatever the default Ren speed is..)

The PX-1 baud rate is a value your programming.

To test the PX-1 after programming it, you will need to connect it to the correct baud rate driver..

1. V2 set to Renard standard protocol speed.
2. Program using the 0-255 values as per the wiki
3. (in my case) V3 with (Renard/Px-1) settings set to the baud rate value programmed to test

If you use the Px-1 utility.. ensure you connect to it using the V2 default Renard baud as opposed to the baud value you actually want to run the PX-1 at.

If I can recall EXACTLY the steps I did.. I will post it.. but I do recall it was a confusion with the programmer baud rate(V2, Renard plugin) and the PX-1 baud rate I wanted.


Reply
TazChaLet
Posts: 3042
(@tazchalet)
Famed Member
Joined: 13 years ago

are you remembering to put the jumper on J4?


Reply
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago

I have put the jumper on J4
The yellow ATTN LED flashes once I apply power to the PX-1
Going to go back thru the process Thursday paying close attention to all the suggestions posted
Thanks in advance
Bert-nc


Reply
Posts: 281
Topic starter
(@bert-nc)
Reputable Member
Joined: 18 years ago

I tried this morning to re-program the PX-1, following the directions suggested.
Did set baud rate on my com port to what came up on the default vixen program.
Think it was 19200 instead of 9600.
I had used the 9600 with no luck yesterday
Still no luck
PX-1 does not indicate (all leds flashing) that sequence accepted
no hair left to pull out, may just have to step back for a while
it is bound to be something simple, or my computer acting up, as it has to reboot any time it shuts down, or restarts
may have to get a pickit3 to be able to set the settings I need
any one have a good link for a pickit3? I have seen them up towards $60
I will try any other suggestions if someone has one
Thanks in advance

bert-nc


Reply
Page 2 / 3
Share: