I am mapping out my future visions, if/when I ever get enough money for all these lights and parts.
Is it possible to interconnect different controllers?
I am currently running 2 Grinch/Ren-C combos with the Ren-T for the ZC.
My vision will be upgrading from 93 channels to 281 overall. In an effort to minimize overall cords, I am thinking of using some Ren24's in with my Grinch/Ren-C's.
Is this possible? Or should I just stick with the Grinches?
You can mix & match as long as you have the ports.
For example, I have 1 Ren64 & 3 Ren24's
Ren64 & 2 Ren24's are on 1 serial port, and my other Ren24 is on the second serial port.
In Vixen you specify which channels go to which port, so I send Ch1 to 112 to Com1 and Ch113 to 136 to to Com2.
I am sure a lot of others do the same. You can't always afford to start all over with controllers, so you add/change as you grow. You won't necessarily be 'interconnecting' the controllers, but adding more channels on different controllers through additional ports (Grinches - Parallel, Renards/DMX - Serial)
Well crap. I was hoping not to have to add ports......
Just a reminder that you can run up to 287 channels off of one com port at 50 ms. You can double that (575) if you bump up to 115,200 kb baud. (I ran 384 channels off of 2 com ports this year without a hiccup.)
rstehle wrote:Just a reminder that you can run up to 287 channels off of one com port at 50 ms. You can double that (575) if you bump up to 115,200 kb baud. (I ran 384 channels off of 2 com ports this year without a hiccup.)
Someone needs to fix the wiki now that has been proven.
