Daisy chaining issu...
 
Notifications
Clear all

Daisy chaining issues

3 Posts
2 Users
0 Reactions
1,457 Views
Posts: 71
Topic starter
(@barryiseeu)
Estimable Member
Joined: 17 years ago
[#17123]

I have a ren 24ss connected to a ren w. works great but from it I have a ren 64 connected through a cat 5 cable. The first 24 channels work great. But the ren 64 works sparodicaly stepping through the channels some will come on others will not, but if you go back down some of the ones that did not come on and ones that came on going up will not come on. Any ideas?


2 Replies
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Make sure you're running at 57600, MARK parity and 2 stop bits. With an SS24 daisy-chaining into a Ren64, you essentially have a 88 channel controller. You're going to need the extra parity/stop bits in the data flow because the XBee's clock runs just a little bit faster than the PICs. The extra bits help slow it down a little as the data goes into the SS24, helping to prevent a data overrun condition.

The 57600 M, 2 setting is set in the Vixen plugin as well as in the comm parameters for the XBee modules. There is no parity setting for the Renard firmware so they should be fine.


Reply
Posts: 71
Topic starter
(@barryiseeu)
Estimable Member
Joined: 17 years ago

Fixed it! Checked the settings. They were correct. The receiver is about 250 yards from transmitter. I had put the receiver at the bottom of my mega tree. When I took the transmitter out to where the tree was, everything worked fine. I raised the receiver up about 4 foot off the ground.... Everything worked great! Thanks for all your help!


Reply
Share: