I have just completed 2 of the SS24 and in the process of testing each one I found that the first one worked OK all channels. The second one all works OK except channel 3 it will not come on. I have changed triac, opto and pic and re-flowed solder joints on all of these components. Following the steps in the Troubleshooting SSR Circuitry Problems the only time I could get ch 3 to light up was when I jumped between pins 4 and 6 of the opto socket. I did have the 5 VDC on 1 of opto when jumper was in place. I am lost as what to do next. Anyone have any suggestions? Thanks
Have you mapped out and followed the traces? Sounds to me like a trace may be bad. If so, it's not a worry, place a jumper wire in where the path of a trace should be, you should be good.
Did the lights come on in step 10 of the troubleshooting SSR Circuitry Problems?
Underdog - have not mapped out traces but will do that after eyes get a rest - their not as good as they once were. Ha
ctmal - NO they do not come on in step 10. All of the other channels will come on except for channel 3 in step 10 table.
Thanks
Ok, that narrows down where the issue could be. Can you check for continuity between Pin 12 of the pic socket and pin 2 of the opto? I would assume at this point that if you check it from the top of the sockets you won't see any continuity. In that case I would reflow the solder joints on the opto and pin 12 of the pic socket and check the traces for issues as stated above.
If you do have continuity then I would look into whether the IC's are fitting into the sockets correctly and making a good connection.
ctmal wrote:Ok, that narrows down where the issue could be. Can you check for continuity between Pin 12 of the pic socket and pin 2 of the opto? I would assume at this point that if you check it from the top of the sockets you won't see any continuity. In that case I would reflow the solder joints on the opto and pin 12 of the pic socket and check the traces for issues as stated above.
If you do have continuity then I would look into whether the IC's are fitting into the sockets correctly and making a good connection.
+1! I agree with this, It seems elementry now that I think about it. But of course I was getting ahead and overthinking, sadly that wasn't the first thing through my head :hmm:! Let your eyes rest. It could be (or is likely) a bad solder check those first, if that is unsuccessful then map the traces. If it is a bad solder or bad trace, no worries, it's an easy fix!
Make sure you don't have a pin that got bent under the chip or socket
I checked for continuity between pins 12 (pic) and 2 (opto) and there were none. I have it between bottom (solder joint) and the top (header pin) at each pin but not between the two. I re-flowed solder joints and still not continuity. I could not see any defect in the trace but solder a jumper between the two and now all works fine. I would have never figured this out without each of you comments so thanks.
Thanks
Danny
Great, glad to hear it's working.
Good deal, glad to hear. If you're worried about this happening again, I'm pretty sure this is an isolated case. These SS boards are high quality and brute force! Carry on with blinky-flashy
