5 volt regulator
 
Notifications
Clear all

5 volt regulator

14 Posts
7 Users
0 Reactions
4,816 Views
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
[#26763]

Would I have a problem if I used the L7805CV, 5 volt regulator in place of the 595-UA7805CKCS on the MiniRen 8/4XB?


13 Replies
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

Should work fine.
/mike


Reply
Posts: 50
(@vegaslight)
Trusted Member
Joined: 14 years ago

Nope I use them all the time. Bought a huge bag full of them for next to nothing... And they work just fine. Not sure about long term, but as of right now all my boards use them and everything working great


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago

Great, thanks
I compared the specs on both and didn't see anything that would hinder it from working satisfactorliy. But just wanted to pass it by you for comments.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago

I mounted L7805CV on the MiniRen8/4XB. I notice that the L7805CV regulator gets fairly warm. While the UA7805CKCS on the RenardSS's doesn't even hint of getting warm.
So does the Radio shack transformer while the Tamura doesn't.


Reply
Posts: 1041
(@n1ist)
Noble Member
Joined: 19 years ago

One warmer than the other implies one of two things (or both): Either one is drawing more current from the regulator or one transformer is supplying a higher voltage. Power (watts) dissipated by a linear regulator is simply (volts in - volts out) * amps drawn.
/mike


Reply
Wayne J
Posts: 7789
(@wayne-j)
Illustrious Member
Joined: 20 years ago
11Bravo wrote:I mounted L7805CV on the MiniRen8/4XB. I notice that the L7805CV regulator gets fairly warm. While the UA7805CKCS on the RenardSS's doesn't even hint of getting warm.
So does the Radio shack transformer while the Tamura doesn't.

I am curious how you ended up with this regulator on a SS when it is not on the BOM or Parts Substitution list? Why not use the LF50CV?


Reply
boyelroy11
Posts: 757
(@boyelroy11)
Prominent Member
Joined: 17 years ago
11Bravo wrote:I mounted L7805CV on the MiniRen8/4XB. I notice that the L7805CV regulator gets fairly warm. While the UA7805CKCS on the RenardSS's doesn't even hint of getting warm.
So does the Radio shack transformer while the Tamura doesn't.

The '12v' transformers that I got from Radio Shack for my MiniRens were putting out 18v and 21v, respectively. You might check for that as far as your heat levels go. Correct part number and all, 12v printed onto the part.


Reply
Posts: 1115
Topic starter
(@11bravo)
Noble Member
Joined: 14 years ago
Wayne J wrote:I am curious how you ended up with this regulator on a SS when it is not on the BOM or Parts Substitution list? Why not use the LF50CV?

My bad, I should have went back and looked at the regulator part number from the SS BOM. I was assuming at the time the MiniRen and the Renard SS had the same BOM part number on the 5volt regulator.

Reason I opted to use the L7805CV was because I didn't have to pay any shipping. I had most of the parts to build the MiniRens on hand and didn't want to make a Mouser order and pay taxes and shipping on a few parts. So I went to Ebay looking for the other components that I needed plus free shipping.

Anyway those regulators I used on the MiniRens get pretty warm and have to remove my finger after about 10 seconds of contact.
I just took some voltage measurements:
Radio shack Transformer output, = 15.5volts
Rectifier output = 18.2volts DC
and I suppose is the reason for the 25volt capacitor on the BOM rather than the 16 volt like is used on the Renard SS's

Regulator output 4.98 volts DC


Reply
ErnieHorning
Posts: 4434
(@erniehorning)
Famed Member
Joined: 19 years ago

It won't hurt anything, the regulator just runs warmer.


Reply
Page 1 / 2
Share: