I have two issues with 48LSD controllers (all controllers are version 3c) . The first issue is one 48LSD is not passing data onto the next controller (this controller is the 3rd 48LSD in the chain). This controller has worked well in the past, I'm just setting it up for Halloween and for some reason its not passing data to the last controller.
The second issue is with a different controller. It appears the ports for strips 11 & 12 are not working but all other ports are working. I swapped PICs in U5 and U6 but that did not fix the issue.
Any troubleshooting ideas would be greatly appreciated.
For #1, try swapping the RS485 chips around and/or swap with working board (mark the chips before removing just in case...). If that doesn't help, check the RJ45 ports closely for crossed pins inside the connector. Next would be to reflow all solder joints in the comm area bits (RS485, RJ45's) and also PIC6 pins.
For #2, If it's all the channels for strips 11/12 this equates to something wrong with PIC #6 or the lower left one when looking at with power input on right. Since you swapped PICs, that leaves the socket and/or surrounding parts. Try reflowing PIC 6 socket and PIC 5 pins 5/6 (comm lines). Ensure there is power across pins 1/14 (5v). Check that there is continuity between between PIC 6 pin 2 and other PIC pin 2's (common oscillator input). Check that the 10K resistor is soldered in and no trace breaks. You should measure 5v or so at pin 4 as it is tied up with the 10K resistor - if not there, the input would float and possibly be in a constant reset loop.
Anyway - that covers the more obvious issues - check for solder bridges, cold solder, broken traces, etc around the PIC 6 area on both boards.
