PI not working
 
Notifications
Clear all

PI not working

32 Posts
9 Users
0 Reactions
11.9 K Views
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago
[#41419]

says fppd is stopped. It it is starting when I hit the start fppd. But it doesn't. And I'm getting this red writing on start up any ideas


31 Replies
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

Also instead of FPP login at the bottom of start up screen. It says (none) login

Sent from my iPhone using Tapatalk


Reply
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

Sent from my iPhone using Tapatalk


Reply
dirknerkle
Posts: 10310
(@dirknerkle)
Illustrious Member
Joined: 18 years ago

Use your browser and go to 192.168.1.4 to get the Falcon page. When Falcon Player is running, you don't use the command line at all unless you want to run some things manually. You use it via the browser.


Reply
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

Right.
But it says it's not running. When I tell it to start running it says it is but doesn't change. Also I have a update. Which I thought might my problem but it doesn't give me the green bar to update it. I have a STC hooked up. But it doesn't show the active time on the status page. But on the about fpp page you can see it's keeping time. It's not Connected to the Internet. So I can get it to come up on PC but nothing seems to be really working. Not sure if I set it up wrong or just don't know how to work it. [emoji20]

Sent from my iPhone using Tapatalk


Reply
Posts: 80
(@jerryg)
Estimable Member
Joined: 11 years ago

Have you got an USB drive inserted? I had the same issue of not starting until I inserted a USB drive for it to save configs and such. Just a thought.

Sent from my iPhone using Tapatalk


Reply
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

Yes. I guess I have it configured right. It flashes so I guess it's working. I was think bout erasing the thumb drive. And trying to configure it again.

Sent from my iPhone using Tapatalk


Reply
ThreeSizes
Posts: 69
(@threesizes)
Trusted Member
Joined: 11 years ago

What is your hostname configured to? It looks like you have it configured to "FPP-Pi 2-01". If that is the case you need to remove the space between Pi 2. You can't have spaces in hostnames.


Reply
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

Green bar shows up after the first manual update. By default you must have a usb drive inserted to get the fppd to start. The newest versions have a configuration setting that allows you to specify using the boot SD card. Until you make that configuration change, you will need a usb drive inserted into the pi.


Reply
Posts: 121
Topic starter
(@jeremy-jackson28)
Estimable Member
Joined: 11 years ago

There is a space between them. I will correct that. I do have a thumb drive connected.

Sent from my iPhone using Tapatalk


Reply
Page 1 / 4
Share: