Hi everyone,
I attached a document showing a diagram of my theoretical network and controller set up. I wanted to make sure it looked correct and had some questions about setting up the lighting show network separate of my home network. Can I assign a static IP address for all the controller, receivers and FPP players? Let me know if you see something incorrect. I have to wait for availability of the F16V4 so I can not test this setup yet. This is why I am asking.
That looks fine
Some things don't look quite right.
1. You are showing a differential expansion board hanging off the F16. It does not have an IP address. Technically it becomes part of the motherboard (F16Vx).
2. The signal from the expansion board to the receivers is NOT Ethernet. It is RS485. NO IPs for these.
3. The use of the remotes off of the serial port of the F16 is RS485. Again, NOT Ethernet. No IPs for these as well.
Curious as to the Beagle Bone Black in the orange box. If this is the show player, why do you have it in "Bridge Mode"?
Thanks for your clarifications that is why I put it up there.
That answers my questions about what devices end up with IP addresses. So just the show router, Beaglebone black player, P10 matrix and the F16V4 will have IP addresses. I wasn't sure about the other receivers.
You also answer my question about the Beaglebone player needed to be in bridge mode to control the other devices. I can just run it as a player instead. I would then only need bridge mode to connect to a laptop and run xlights from that laptop. Which isn't how I want to do it.
If you have pixels (or other props) running directly off that particular BBB, then bridge mode works for testing from the sequencing computer. If you aren't pushing pixels directly from that BBB, it is not necessary to switch it in and out. Your sequencing computer should be able to send directly to the active controllers.
Someone else will have to advise you on the use of the three remotes off the onboard serial port. It looks good to me, but not a lot of experience running more than one coming off the main board's serial to remotes. All mine come from the expansion boards.

