Notifications
Clear all

Mapping Issue

22 Posts
8 Users
0 Reactions
7,768 Views
Posts: 259
Topic starter
(@cmschleich)
Reputable Member
Joined: 11 years ago
[#42401]

I have Vixen 3.3 running on a PC. I have a F16v2R and an E682. I'm struggling to get my sequence to play to the right elements when using FPP.

Here's my troubleshooting sequence.

F16v2R onboard test patterns activate the right lights.
E682 onboard test patterns activate the right lights.
Vixen Webserver tests activate the right lights.
FPP test patterns activates the right lights and colors.
Vixen 3.3 playing the sequence activates the right lights.
The sequence playing through the FPP does not activate the right lights, or the right colors.

I have a few fuzzy spots about my mapping across all these platforms, I think I only understand Universe/channel/output mapping concept 50% at this point, but I don't want to add those comments yet. What else would you check based on this evidence series?

Out of curiosity, anyone live in Orange County, CA?


21 Replies
MartinMueller2003
Posts: 7613
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

The issue may be on the FPP and the start channels you are assigning to the universes. Please post a picture of your config on the FPP and then the config on the F16v2. After that we will most likely ask about the patching on the PC.


Reply
Posts: 274
(@kartingted)
Reputable Member
Joined: 13 years ago

When you export from vixen you get the screen with start channels for controllers
You need to make sure they are the same in fpp


Reply
Posts: 259
Topic starter
(@cmschleich)
Reputable Member
Joined: 11 years ago

IGNORE FOR NOW. IGNORE FOR NOW. Through capturing all the pictures I see an issue related to what kartingted said. I don't quite get what the export is doing with the channels given that I've told them what to be in the Display settings. Going to run some tests.

Thanks, feels like one I'm going to dump a dozen hours into if left to my own.

In order:
E682 string mapping. (Unicast, universes 1 through 12, all set for 510, I'm reserving channels 1-9 for three hard addressed floods I may use in the future. I've zeroed out all outputs I'm not useing)
F16V2R E131 config
F16V2R string mapping. (I'm using outputs 1 and 2, and 9 an 10, so as to be on different power buses)
FPP output map
Vixen display settings for F162VR
Vixen display settings for E682 (see next post, I hit attachment limit)
Vixen sequence export screen

If I try to use manually set starting addresses for the F162VR for universes 5, 6, 7, and 8 the assigned element patches never bind to the controller outputs.

E682 mapping
FPP E131 Config Map
F16V2R String mapping
FPP Map
Vixen Display settings, F16VR2

Reply
Posts: 259
Topic starter
(@cmschleich)
Reputable Member
Joined: 11 years ago

Not sure how to delete the post above.

I've got it. I did not recognize the implication to what was shown on the export screen. So I understand how I fixed it, but I don't understand what I was doing to make this twisted. I configured the Vixen Display, and Vixen drove the elements correctly with that mapping, why would that not inherently be part of the export since it works when Vixen is driving the sequence?

Both of you guys rule for responding. Without both posts I wouldn't have gone down the path needed.

First year in this hobby... the lessons and hangups hardware, software, and handyman (house) have been endless.


Reply
Page 1 / 5
Share: