FPP not recognizing...
 
Notifications
Clear all

FPP not recognizing sequence length

12 Posts
5 Users
0 Reactions
5,145 Views
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago
[#38781]

I've created a test animation (sequence with no audio) in xlights, adjusted the length from 30 seconds to 5 seconds, saved, uploaded to FPP.

Except FPP thinks the sequence is still 30 seconds long and so is blank the other 25 seconds before repeating. What's going on here ? Using v1.6


11 Replies
smeighan
Posts: 2595
(@smeighan)
Famed Member
Joined: 15 years ago

Delete the fseq after u changed the length and save again. The new faeq will then be correct length

Sent from my iPhone using Tapatalk


Reply
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago

Nope.. tried that... did not work.


Reply
Posts: 1049
(@phrog30)
Noble Member
Joined: 12 years ago

Any fpp questions really should be asked at the fpp site (Falcon Christmas). That's where all of the fpp experts hang out. [emoji16]


Reply
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago

I started a thread there too... just figured somebody here might know as well. Thanks!


Reply
Posts: 843
(@captainmurdoch)
Prominent Member
Joined: 14 years ago

Did you adjust the length in the timeline or when you created the sequence? If you just move the points on the timeline the sequence file itself will still be 30 seconds long but will only have sequence data for 5 of those.


Reply
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago

I changed the sequence duration in the settings from 30 to 5


Reply
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago

Mystery sort of solved.... in Xlights, you MUST set the effect duration when you're in the creation dialog, you apparently can NOT go back and change it afterwards.


Reply
Posts: 1133
(@toozie21)
Noble Member
Joined: 19 years ago
IrishAle wrote:Mystery sort of solved.... in Xlights, you MUST set the effect duration when you're in the creation dialog, you apparently can NOT go back and change it afterwards.

Thank you for that, that explains some things that were..... bugging me.

Short and badly typed since written from my phone...


Reply
Posts: 108
Topic starter
(@irishale)
Estimable Member
Joined: 12 years ago

Hold on.... turns out there's a known bug, that had I slogged through github I would have seen it.

The solution was pointed out to me:

1. CLOSE Xlights.
2. manually delete the fseq file.
3. open Xlights, open the sequence, and save to create the new, correct-length fseq file.


Reply
Page 1 / 2
Share: