FFP and Servo Contr...
 
Notifications
Clear all

FFP and Servo Controller

4 Posts
3 Users
0 Reactions
1,710 Views
Posts: 2
Topic starter
(@trevlawler)
New Member
Joined: 4 years ago
[#56160]

Hi I'm currently running a show off of a RPi3 and 2x LOR boxes (CTB16PC and a CMB24D with 8x RGB floods) via DMX in FPP.

I'd like to work on adding some kind of servo props to the mix. Would I be able to connect a Lynxmotion SSC-32U USB Servo Controller via USB for my needs? Is there a recommended servo controller with FPP? I could always go the route of getting a LOR ServoDog but the SSC-32U seemed to be the better board.

I only plan on running maybe 3 servos total for now.

Thanks!


3 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

ESPixrlStick V4 supports up to 16 servo outputs via the relay config port. It drives a 16 channel I2C device.


Reply
Posts: 629
(@dkulp)
Honorable Member
Joined: 14 years ago

Someone would have to write an output driver for the Lynxmotion most likely. I have no idea what kind of protocol it expects for its data.

FPP DOES have support for PCA9865 servo boards built in (Other tab). You connect 4 wires (i2c bus) from the board to the Pi/BBB and it's pretty simple to setup. They are also super cheap. $20 could drive 48. https://smile.amazon.com/Organizer-Channel-PCA9685-Arduino-Raspberry/dp/B07Z8R2YB9


Reply
Posts: 2
Topic starter
(@trevlawler)
New Member
Joined: 4 years ago

Awesome, thanks everyone! I'll check these out.


Reply
Share: