ETH0 Connection Iss...
 
Notifications
Clear all

ETH0 Connection Issue

4 Posts
3 Users
0 Reactions
2,376 Views
Posts: 82
Topic starter
(@mikesd)
Estimable Member
Joined: 12 years ago
[#38372]

I brought up a 2nd PI v2 to use as a spare. After the install, I couldn't connect to the unit via my ehternet.

I did some looking and googling and it seemed I was missing something, during the install. On my working PI, I had an eth0 file. I think it was interface.eth0 or something like that. Regardless of the name, I just copied it and put it in the same location on my new PI. Then, I was able to connect.

However, that doesn't address my concern.

1) Why wasn't the file there in the first place?
2) Is just copying it ok, or does it contain other info that might now be wrong?
3) If I want to redo the install, what do I have to do, to insure that the file is created the next time?

I will say that the Ethernet connection was not established until part way through the install process. Could that have cause the problem?


3 Replies
MartinMueller2003
Posts: 7614
(@martinmueller2003)
Illustrious Member
Joined: 14 years ago

It could but you can prove it by starting the install over again with a blank SD card and the ethernet cable attached. In my experience, it should not matter but "should" is not "does".


Reply
tucsonlights
Posts: 667
(@tucsonlights)
Honorable Member
Joined: 15 years ago

I would post this over in Falconchristmas.com Chris is really good about getting problems resolved.


Reply
Posts: 82
Topic starter
(@mikesd)
Estimable Member
Joined: 12 years ago

Done


Reply
Share: