Quick DMX Terminato...
 
Notifications
Clear all

Quick DMX Terminator

11 Posts
5 Users
0 Reactions
14.5 K Views
tconley
Posts: 410
Topic starter
(@tconley)
Honorable Member
Joined: 19 years ago
[#4563]

How do I make a quick and Dirty DMX terminator? I need to terminate my pixel string i think that maybe why i get periodic lockups of the pixels.


10 Replies
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

solder a 120R resistor on the last unit.

Cheers
Matt


Reply
tconley
Posts: 410
Topic starter
(@tconley)
Honorable Member
Joined: 19 years ago

where can i solder it? To a cat5 pigtail and if so to what pair.


Reply
Matt_Edwards
Posts: 2664
(@matt-edwards)
Famed Member
Joined: 18 years ago

carefully stick the ends of the resistor in the sockets for pins 2 and 3 on the dmx output of the last device in the chain
or just cut an premade cable and solder it across orange - orange/whilte. make sure these are wire pair 1.
Cheers
Matt


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

110-120 ohm resistor works fine. If Radio Shack is your only option you may need to solder a could of resistors together to get there.


Reply
Posts: 386
 JEC
(@jec)
Reputable Member
Joined: 19 years ago
Matt_Edwards wrote:carefully stick the ends of the resistor in the sockets for pins 2 and 3 on the dmx output of the last device in the chain
or just cut an premade cable and solder it across orange - orange/whilte. make sure these are wire pair 1.
Cheers
Matt

Note that the pixels were specifically designed *not* to use any standard DMX pinout or wiring pattern...


Reply
tconley
Posts: 410
Topic starter
(@tconley)
Honorable Member
Joined: 19 years ago

so what wire pairs should i solder a terminating resistor to.


Reply
Posts: 386
 JEC
(@jec)
Reputable Member
Joined: 19 years ago

Pins 7 & 8 (brown, brown/white on the patch cables I use)

http://www.response-box.com/rgblights/Media/docs/fullpixelschematic.pdf

If you pick the wrong pair you'll put 120 ohms across your +12v supply and ground.


Reply
wjohn
Posts: 1102
(@wjohn)
Noble Member
Joined: 20 years ago

That would be interesting

12 V supply, 120 ohm resisitor. a bit of ohm law magic..

12/120 = 0.1 Amps

Power disapation

12 * 0.1 = 1.2 Watts into a 1/4 resistor.

sniff, the grey smoke is coming out Mom!!!


Reply
tconley
Posts: 410
Topic starter
(@tconley)
Honorable Member
Joined: 19 years ago

LOL thats funny


Reply
Page 1 / 2
Share: