JEC wrote:
Finally, a couple of us were chatting last night about (possibly) editing the pixel string code to speak Renard. Then, no DMX dongle would be necessary. Just serial via RS485. It would certainly be a springtime project.Hmmmm.........
I'm looking at the Enttec open DMX dongle. At $60, it hurts the pocketbook. But it is an 'open' design. And I believe it can be built for ~$10, which may be cheaper than a Renard controller.
I etched my first-ever PCB last week, so hopefully I'll be able to build and test this within the next few weeks.
NogginBoink wrote:I'm looking at the Enttec open DMX dongle. At $60, it hurts the pocketbook. But it is an 'open' design. And I believe it can be built for ~$10, which may be cheaper than a Renard controller.I etched my first-ever PCB last week, so hopefully I'll be able to build and test this within the next few weeks.
You'll be dissapointed with the open. Everyone eventually is. They just don't hack the pace, and you'll end up with missing frames etc, esp when you start doing greater than 20fps.
mrpackethead wrote:You'll be dissapointed with the open. Everyone eventually is. They just don't hack the pace, and you'll end up with missing frames etc, esp when you start doing greater than 20fps.
Hm. I see. So maybe going straight to a custom USB based DMX512 converter is the way to go.
Thanks for the opinion; I'll pass on this project and move on to the next one.
NogginBoink wrote:Hm. I see. So maybe going straight to a custom USB based DMX512 converter is the way to go.Thanks for the opinion; I'll pass on this project and move on to the next one.
Or RJ's Lynx Dongle that is like $40 to make and works great!! I will be using 4 of them next year (unless this so called multi universe dongle makes the scene 🙂 )
Ben
mrpackethead wrote:Did you read my signature?
I tried it, it's dead. Can't even ping it.
