Point Source Pixels...
 
Notifications
Clear all

Point Source Pixels Remixed

60 Posts
16 Users
0 Reactions
19.4 K Views
Virtus
Posts: 1182
(@virtus)
Noble Member
Joined: 19 years ago

Don't they make clear C9s, too?


Reply
Posts: 1084
 ben
(@ben)
Noble Member
Joined: 19 years ago
Virtus wrote:Don't they make clear C9s, too?

yes.


Reply
Posts: 6728
(@p-short)
Illustrious Member
Joined: 20 years ago

OK, it looks like I misunderstood what you were saying. Are you thinking of using a clear/white C9 cap (minus the original innards) with a JEC mini-pixel (or some similar device)?


Reply
Jeff Millard
Posts: 1450
(@jeff-millard)
Noble Member
Joined: 19 years ago
jeffmill wrote:RGB. ...a similar effect from a C9 bulb

Sorry, should have been more "clear" here... "a C9 'clear' plastic faceted shell that goes over a small button LED"

JEC wrote:Are you envisioning some sort of surgery to be performed on the Target bulbs?

Yep, the faceted C9 is just a clear plastic shell that slips over a flat faced LED. Some of them pop-in to a shell the size of a C9 socket. Others screw into sockets a little larger than a mini lamps. I can see getting a small RGB LED into both shells. You can get some nice spread of an RGB LED with them. I had one that came in a parts grab bag I bought. I lit them with the SSR tester Wayne sold me at the Philly mini. I think that these shells slid over RGB pixels would look great wrapped all the way around my roof.

But, as I said before... this is just a wish. I already have a plan for 2009, and this isn't in it because of the development status of a DIY point source pel. I only spoke of this as Bob and I were chatting about the idea elsewhere. I haven't even thought of the cost. Would it be a less expensive idea, to have RGB pixels in C9 shells, with only 4 to 8 sets of controllers. Then wire them in a chase pattern so every 6th bulb is on the same color. If so, then I don't need any controller. I'll just make my own full wave strings in groups of 35, 50 or 70 depending on the voltage of the LEDs. Then just control them with dimming channels. I don't need to reinvent the wheel. All I want is to be able to color mix RGB LEDs. People looking at my display won't know or even understand how it's controlled. In fact, typing this post has just caused me to rethink my idea. I think I just came up with a solution to my idea...

But my idea is hijacking the development thread....

Jeff


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago

Got to read the words on the page.

jeffmill wrote:...hoping to get a similar effect from a C9 bulb with a single tri color LED.

I think his point is to use a C9 bulb as the container for an LED. Jeff the record my blue LED string I bought when they were first out has a C9 shaped diffuser over each led, the big difference is its plastic.


Reply
Page 12 / 12
Share: