DMX shield
 
Notifications
Clear all

DMX shield

9 Posts
6 Users
0 Reactions
4,381 Views
Posts: 68
Topic starter
(@wootin24)
Estimable Member
Joined: 15 years ago
[#24393]

Hi, I was wondering if you guys think one of these would work with renard board and the arduino to make a standalone light show. I don't know what I would use it for but it could be good for testing and other things

https://tindie.com/shops/search/?q=DMX

Thanks


8 Replies
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

I suppose that depends on your definition of "stand alone". This board will enable your arduino to send (or receive) a DMX signal.

The data for sequencing (DMX or Renard or other), however, can be huge, depending on what you are trying to control.
Eg. 24 channels at 50ms samples - 480 bytes per second. Got a two minute song to sequence? 57,600 bytes.

So "stand alone" seems a bit far fetched, unless you are putting some type of FLASH card into the mix, to store the files.

As a bridge for experimentation? $14.00 seems a reasonably cheap price to pay.


Reply
Posts: 68
Topic starter
(@wootin24)
Estimable Member
Joined: 15 years ago

I just meant as a way to test controllers with a pre layed out loop. Something short that maybe just runs through the channels


Reply
Posts: 127
(@s196635)
Estimable Member
Joined: 14 years ago

Yes that would work just fine.

wootin24 wrote:I just meant as a way to test controllers with a pre layed out loop. Something short that maybe just runs through the channels

Reply
LabRat
Posts: 2981
(@labrat)
Famed Member
Joined: 17 years ago

Well.. one area to investigate first, is whether you can generate the "BREAK" using this hardware.
A quick google search leads to another 'duino' solution that demonstrates that this hardware may be good for receiving, but not necessarily the ideal choice for being the source of the DMX signal. (Typically a second IO pin is used to generate the 88us "break" that is required, prior to the DMX payload).

http://forums.netduino.com/index.php?/topic/1501-simple-dmx-transmitter/


Reply
Page 1 / 2
Share: