What I haven't seen discussed (maybe I missed some reason it's not feasible?) is the classic "set start address using a program mode jumper" approach.
e.g. if the jumper is bridged, the device sets its start address based on the dimming values for devices 1 and 2 in the universe, if the jumper isn't bridged, it just uses its programmed start addy.
A single jumper is a lot easier than full-on DIPs, but this approach means you don't need to implement fullblown RDM.
cypress1138 wrote:The value of 0x0F is the RDM code for DMX_START_ADDRESS... I think. Am I correct? Also, is their a specific start code that I should use to initiate setting the address?
The start code for RDM is 0xCC, you want to avoid this unless you are communicating via RDM. As far as other codes its up to you, like I said earlier you want to pick one that isn't already used by a commercial manufacturer (see the ESTA link I posted). I'm not sure what start code folks here have used...further I don't know if others verify start codes like I do (dimmer values == 0, 0 dump the values).
Entropy wrote:What I haven't seen discussed (maybe I missed some reason it's not feasible?) is the classic "set start address using a program mode jumper" approach.e.g. if the jumper is bridged, the device sets its start address based on the dimming values for devices 1 and 2 in the universe, if the jumper isn't bridged, it just uses its programmed start addy.
A single jumper is a lot easier than full-on DIPs, but this approach means you don't need to implement fullblown RDM.
The one problem I do see with either the dip switches or a jumper is that you have to have access to the board to change either one. I would like to be able to seal up the board semi-permanently to make it water tight. If I have to break that seal every time I would like to change an address this could be a problem and this is why I was looking at the Renard protocol in the first place.
DynamoBen- Thanks for the link I missed it the first time. This will definitely help in picking an unused start code. Thanks again!
DynamoBen -
The start code for RDM is 0x40 ...
I think RDM start code is 0xCC. who's right?
-Ed
j1sys wrote:DynamoBen -I think RDM start code is 0xCC. who's right?
-Ed
Checked the spec just now 0xCC is correct. I pulled the other number out of some old code (code that apparently didn't work). Sorry for the confusion, previous post updated.
