DMX Pixel String
 
Notifications
Clear all

DMX Pixel String

34 Posts
10 Users
0 Reactions
21.2 K Views
Posts: 859
(@smartalec)
Prominent Member
Joined: 17 years ago

I asked that orginal question on how to do the oven,
an after searching the internet here's one i found, http://www.stencilsunlimited.com/product_info.php?products_id=424&tab=specs
i figure with all the money we spend on blinky flashie, it might be worth getting a decent one an having a professional job every time.
just my (.02cent au, wich aint worth alot at the moment) 😀

cypress1138 wrote:
As far as how I am planning on soldering all this up I have been reading up on how to make your own reflow oven out of a toaster oven. Which is kind of funny because my wife has been hinting lately that she wants to get a new toaster oven 😀 I need to dig around at work because I think I've got enough pieces and parts laying around to make the controller for the oven (thermocouple, temp controller, opto-coupler, solid state relay, etc.)

Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
smartalec wrote:I asked that orginal question on how to do the oven,
an after searching the internet here's one i found, http://www.stencilsunlimited.com/product_info.php?products_id=424&tab=specs
i figure with all the money we spend on blinky flashie, it might be worth getting a decent one an having a professional job every time.
just my (.02cent au, wich aint worth alot at the moment) 😀

My two favorite methods are:
http://www.sparkfun.com/commerce/tutorial_info.php?tutorials_id=60
http://www.sparkfun.com/commerce/tutorial_info.php?tutorials_id=59


Reply
Posts: 2630
(@dynamoben)
Famed Member
Joined: 19 years ago
aussiephil wrote:
Cypress: why not use a switch-less DMX setting process like RJ and I both do, it's simple and effective. This also allows for easy move to RDM or alt start code setting by a firmware change.

You could do both. For those that want dips that can override the dip-less addressing method when the dips are set > 0. I've done that before, if the dips are at 0 then RDM address takes over. Food for thought.


Reply
Posts: 136
(@j1sys)
Estimable Member
Joined: 17 years ago

another thought. i use mcp23s017 chips anytime i need more i/o. you can bit bang an spi interface to it (if your pic doesn't already have a spi controller) and then get 16 lines with pullups etc. for 3 pins of i/o. or use mcp23017 and do it with i2c with 2 pins.

or just use a 28 pin variant of the pic series you are using. then you have plenty of more i/o.


Reply
Posts: 84
Topic starter
(@cypress1138)
Trusted Member
Joined: 18 years ago
aussiephil wrote:Cypress: why not use a switch-less DMX setting process like RJ and I both do, it's simple and effective. This also allows for easy move to RDM or alt start code setting by a firmware change.

cheers
Aussiephil

So basically what I have gathered is that I would need to program my firmware so that when a start code of say 0x0F is received the firmware will then use the next 2 bytes as the start address of the unit. The value of 0x0F is the RDM code for DMX_START_ADDRESS... I think. Am I correct? Also, is their a specific start code that I should use to initiate setting the address?


Reply
Page 5 / 7
Share: