Yet Another LED Str...
 
Notifications
Clear all

Yet Another LED Strip PCB

11 Posts
4 Users
0 Reactions
8,866 Views
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago
budude wrote:You might look at supertax CL2 constant current drivers - they aren't super expensive, have temperature compensation and support a wide range of voltage.

Yes I did. Apart from the availability issue, they are fixed constant current. Also the CL2 has Vab of about 5 to 6 V. Blue and green LEDs can have a Vf of 3.1 to 3.3 Volts. worst case 6x3.3 + 6 =25.8v. The devices won't be operating in their constant Current mode with a 24v PS.
I tend to drive my Green LEDs lower thn Red and Blue and the Reds as high as I can get. so having the ability to tweak the currents is a benefit.

Phil, re temp compensation, will it help to swap the two diodes for a low voltage ( 2.7 or 3.3 V) Zener?


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

Ok have done a bit more research

these are the three possible contenders for 20mA Constant Current Sources/limiter.
Edit: R5 should be 18R


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

Please excuse a stupid question from someone who only dabbles in h/w- is the R mean "ohms" so 18R is an 18 ohm reisitor (100R is 100 ohms)? I've always wodered about that but never had the opportunity to ask...


Reply
Matt_Edwards
Posts: 2664
Topic starter
(@matt-edwards)
Famed Member
Joined: 18 years ago

Absolutely correct
18R = 18 Ohms
47R5 = 47.5 Ohms
1k = 1000 ohms
1k2 = 1200 ohms
etc
same goes for Capacitors 100nF was preferred over 0.1uF

The idea was to drop the decimal point in the days of hand drawn circuits where spurious specks of dust changed the value. I don't have any reference to this process, but was told by a old knowledgeable bloke when I was a young'n do my EE degree.


Reply
CaptKirk
Posts: 2200
(@captkirk)
Noble Member
Joined: 16 years ago

Thank you- I learned something today (the xRx or xKx is something I did not know), but my brain is now full. 😉


Reply
Page 2 / 3
Share: